Proofs of these twine-bound pages are taken on a hand-press, passed to the reviser for comparison with the galley-proofs returned by the author, and if the latter has expressed a wish to see a second revise of the proofs, they are again sent to him. For such a "second revise" and any further revises an extra charge is made. The proofs to which an author is regularly entitled are a duplicate set of the first revise, a duplicate set of "F"-proofs,--to be mentioned later,--and one set of proofs of the electrotype plates; though it may be added that the last is not at all essential and is seldom called for.
Usually the author does not require to see another proof after the second revise, which he returns to the printer with his final changes and the direction that the pages may be "corrected and cast," that is, put into the permanent form of electrotype plates. Some authors, however, will ask to see and will make alterations in revise after revise, even to the sixth or seventh, and could probably find something to change in several more if the patience or pocketbook of the publisher would permit it. All the expense of overhauling, correcting, and taking additional proofs of the pages is charged by the printer as "author's time." It is possible for an author to make comparatively few and simple changes each time he receives a new revise, but yet have a much larger bill for author's changes than another who makes twice or thrice as many alterations at one time on the galley-proof, and only requires another proof in order that he may verify the correctness of the printer's work. The moral is obvious.
After the pages have been cast, further alterations, while entirely possible, are quite expensive and necessarily more or less injurious to the plates.
The author having given the word to "cast," the pages of type are laid on a smooth, level table of iron or marble called an "imposing stone." They are then enclosed--either two or three or four pages together, according to their size--in iron frames called "chases," in which they are squarely and securely "locked up," the type having first been levelled down by light blows of a mallet on a block of smooth, hard wood called a "planer." This locking-up of the pages in iron frames naturally corrects the defects noted in the twine-bound pages, and not only brings the type into proper alignment and adjustment, but prevents the probability of types becoming displaced or new errors occurring through types dropping out of the page and being wrongly replaced.