(290) Hinged to one side of the headstock framing is the lever =T=—known as the “long lever”—at each end of which pins are fastened, which carry the bowls =R R^{ 1}=. Fastened to the carriage by bolts are two horn brackets =S S^{ 1}=, to which power of adjustment is given. The underside of the brackets is curved, and they are fixed at such a height, that, as the carriage approaches either end of its run, one of them will engage with the bowl or runner carried on a stud fixed in the end of the long lever, as shown very clearly by the dotted lines. At the outer end of the long lever, the bell crank lever =Q= is pivoted, and is ordinarily drawn towards the end of the long lever by a spiral spring =O=. In this way, when the latter has assumed a position in consequence of the pressure of the horn brackets =S S^{ 1}=, the pressure of =Q= upon it prevents it from moving until a similar force is again applied. In short, the long lever is locked.
(291) On the cam shaft three cam or eccentric surfaces are placed, marked respectively =W Y= and =Z=. These are shown with their connections in detached views. The cam =W= is compounded with the male half of the friction clutch =X=, and can slide along with the half clutch upon a feather key fixed in the shaft. The other half of the clutch is loose upon the shaft, and has formed upon its boss a spur pinion which, as shown in Fig. 153, engages with the teeth of the backing-off wheel =A^{ 1}=. Thus the continuous rotation of the latter leads to a similar movement of =X=, and, as a consequence, the latter is always in a state of readiness to rotate the cam shaft. A spiral spring surrounds the cam shaft, being sunk into a recess in the bearing and continually pressing upon a flange formed on the sliding half of the friction clutch, thus tending to force the latter into gear. On the inner side of the flange two cam surfaces are formed, as shown at =V=, with which the nose of the rocking or escape lever engages. The latter is connected by a short rod to the end of the long lever, the whole attachment being very clearly indicated in the illustration. Suppose the end of the lever to be in the position shown in the left hand view of =V=, the friction clutch would then be engaged, and the cam shaft would revolve until the outer cam surface on =V= came into contact with the end of the lever, when the sliding half clutch would be disengaged and arrested, and the motion of the cam shaft would cease. In this position the parts remain until the long lever is again moved, this time having its inner end depressed by reason of the contact of the bracket =S^{ 1}=, and bowl =R^{ 1}=. The nose of the escape lever is then moved off the outer cam surface into the flat or level portion of the inner cam course. This permits the re-engagement of the friction clutch, and the cam shaft makes the second half turn, causing the inner cam course to engage with the nose of the lever and again disengaging the friction clutch. The raised cam surfaces on =V= are directly opposite one another, so that the cam shaft can only make a half turn before it is disengaged. The next movement of the long lever, which takes place at the end of the next outward run, is caused by the engagement of =S= and =R=, and the escape lever nose is then moved on to the level surface of the outer cam course. This alternate movement of the long lever takes place, as will be readily understood, when the carriage reaches the termination of its inward and outward runs.