[Illustration: MAKING BIAS STRIPS FOR FACINGS]
Avoid too frequent fittings. The bias portions of the bodice are liable to stretch out of shape and too much handling of the waist takes away the freshness. This is one reason why it is advisable to make the sleeves and collar first in order that the whole waist may be fitted at once and all alterations made to fit both sides. A perfect figure is the exception rather than the rule and the side that is not developed should be well fitted, whether sleeve or bodice.
If it is necessary to lengthen the sleeve, say two inches, cut the pattern at right angles to the lines indicated by the dots, above and below the elbow. The slashing should be done exactly at the same distance apart in the upper and under portions of the sleeve in order to retain the proper shape and size of the top and bottom. Separate the parts, allowing one inch above and one inch below the elbow.
To shorten the sleeve, lap the slashed part or lay a fold in the pattern instead of slashing. In either case, care should be taken that the fold or lap is of even width all the way across, so that the original shape of the sleeve will not be lost.
Too much care cannot be taken in arranging the pattern of the sleeve according to the thread of the goods. Especially is this the case in the two-piece or coat sleeve. Generally the top part of the outside seam and the lower part of the same side should be placed at the edge or fold of the goods, so that the two run in the same straight line. In all cases, the foundation sleeve or lining should be cut and fitted before the outer portion is adjusted. Ample time should be given to the fitting and basting of the sleeve. The "set" of the sleeve is very often unsatisfactory because the cutting and original basting was done in a careless manner. Remember that greater care is required in sleeve making than in any part of the garment. Each sleeve is complete in itself and one must not deviate from the other in size, arrangement or ornament, or general appearance. They should be cut, basted and fitted alike and if the arms differ in size or length the sleeves must be so adjusted as to conceal the inequality.
The sleeves should be made at the same time and before the cuffs, then the cuffs, puffs, or whatever special trimming is to be applied to them should be put on both sleeves at the same time. If the second sleeve is not made or trimmed until after the first is finished, it will be much more difficult to secure exactly the same effect. If it is impossible to complete both sleeves at one time, make the sleeves one day and the cuffs or trimming the next day.