«Definition of Osmotic Pressure.»—‹The hydrostatic pressure which is necessary to bring the solution into equilibrium with the pure solvent, when the two are separated by a semipermeable membrane, may be defined, according to van 't Hoff, as the measure of› what is called the ‹osmotic pressure of the solution›. We note that this definition still does not commit us to any theory as to the origin of the pressure, but merely ‹formulates› an ‹experimental relation›.
«Measurement of Osmotic Pressure.»—More perfect semipermeable membranes can be produced. These make possible quantitative measurements of the hydrostatic pressure on a solution, when equilibrium between the solution and the pure solvent [p011] has been reached. Such membranes were first used by Pfeffer. They consist of certain gelatinous precipitates, notably copper ferrocyanide. Films of these precipitates may be formed, under proper conditions, which are permeable to water but not to certain solutes, such as cane sugar, glucose and galactose.
By precipitating these membranes in the pores of unglazed clay cells, especially by the process devised by Morse,[7] we may make them sufficiently strong to resist enormous pressures—some used by the Earl of Berkeley were found to withstand a pressure of 130 atmospheres. The hydrostatic pressure required to produce equilibrium may then be measured in either of two ways. The first method, used originally by Pfeffer and more recently by Morse and Frazer[8] and their collaborators in a wonderfully conscientious study of osmotic pressures, consists in allowing the hydrostatic pressure to establish itself by the passage of very small quantities of the solvent, through the membrane, into the tightly closed cell containing the solution. When the resulting pressure produces a condition of equilibrium, it is measured[9] by a manometer connected with the solution, much as a gas pressure may be measured (Fig. 3).[10] This process requires considerable time for exact measurements—weeks, during which the cell must be kept at a constant temperature. The second method, which has been used by Berkeley and Hartley,[11] is very much more rapid and requires only a few hours for the measurement. It consists in having the pure solvent within the cell, instead of outside of it, and in [p012] exerting an external pressure on the solution outside of the cell, until a delicate manometer, communicating with the pure solvent, shows that water does not pass through the membrane in either direction—equilibrium having been reached.