When the charge has been placed in the bore-hole, and the fuse laid to it, the hole needs to be tamped, that is, the portion above the charge has to be filled up with some suitable substance. For this purpose, a “rammer,” “stemmer,” or “tamping iron,” as the instrument is variously called, is required. This instrument is illustrated in Fig. 21. It consists of a metal bar, the tamping end of which is grooved to receive the fuse lying against the side of the bore-hole. The other end is flat, to afford a pressing surface for the hand, or a striking face for the hammer when the latter is needed. To prevent the danger of accidental ignition from sparks caused by the friction of the metal against silicious substances, the employment of iron stemmers has been prohibited by law. They are usually made of copper or phosphor-bronze, the latter substance being more resisting than the former.
Sometimes in wet ground it becomes necessary to shut back the water from the bore-hole before introducing the charge of gunpowder. This happens very frequently in shaft sinking. The method employed in such cases is to force clay into the interstices through which the water enters. The instrument used for this purpose is the “claying-iron” or “bull,” represented in Fig. 22. It consists of a round bar of iron, called the stock or shaft, a little smaller in diameter than the bore-hole, and a thicker portion, called the head or poll, terminating in a striking face. The lower end of the shaft is pointed, to enable it to penetrate the clay, and the head is pierced by a hole about an inch in diameter to receive a lever. Clay in a plastic state having been put into the bore-hole, the bull is inserted and driven down by blows with the sledge. As the shaft forces its way down, the clay is driven into the joints and crevices of the rock on all sides. To withdraw the bull, a bar of iron is placed in the eye and used as a lever to turn it round to loosen it; the rod is then taken by both hands and the bull lifted out. To allow the bull to be withdrawn more readily, the shaft should be made with a slight taper and kept perfectly smooth. As the bull is subjected to a good deal of heavy hammering on the head, the latter part should be made stout. This tool, which should be considered as an extra instrument rather than as an essential part of a blasting set, is a very serviceable one, and should always be at hand in wet ground when loose gunpowder is employed.