The selection of the proper colour constitutes a subject for the exercise of judgment and skill on the part of the smith. For rock drills, straw colour is generally the most suitable when the work is in very hard rock, and light blue when the rock is only of moderate hardness.

The processes of hardening and tempering drills are as follows: When the edge of the bit has been formed in the manner already described, from 3 to 4 inches of the end is heated to cherry redness, and dipped in cold water to a depth of about an inch to harden it. While in the water, the bit should be moved slightly up and down, for, were this neglected, the hardness would terminate abruptly, and the bit would be very liable to fracture along the line corresponding with the surface of the water. In cold weather, the water should be slightly warmed, by immersing a piece of hot iron in it, before dipping the steel. When a sufficient degree of hardness has been attained, the remainder of the hot portion is immersed until the heat is reduced sufficiently for tempering. At this stage it is withdrawn, and the colours carefully watched for. The heat which is left in the stock will pass down to the edge of the bit, and as the temperature increases in that part the colours will appear in regular succession upon the filed surface of the edge. When the proper hue appears, the whole drill is plunged into the water and left there till cold, when the tempering is complete. When the edge is curved or “bowed,” the colours will reach the corners sooner than the middle of the bit. This tendency must be checked by dipping the corners in the water, for otherwise the edge will not be of equal hardness throughout. As the colour can be best observed in the dark, it is a good plan to darken that portion of the smithy in which tempering is being carried on.

Rock Blasting — Part 7

The degree of temper required depends upon the quality of the steel and the nature of the work to be performed. The larger the proportion of carbon present in the metal, the lower must be the temper. Also the state of the blunted edges, whether battered or fractured, will show what degree of hardness it is desirable to produce. From inattention to these matters, good steel is not unfrequently condemned as unsuitable.

Rock Blasting — Part 7