[Illustration: Cross Section of Standard Screwed Shoe.]
A pegged shoe is made in much the same way as the standard screw, except that wooden pegs are used instead of wire to fasten the sole together.
The nailed method of shoemaking consists in nailing the soles together around the edge. It is used principally for heavy, cheap shoes.
The old-fashioned shoemaker formerly made shoes by hand as follows:--A last, which is a wooden model of a foot, was used, and pieces of leather were pasted here and there on it so as to build up a model conforming to the measurements of the foot. Then paper patterns of the upper leather were made from the last, and from these the upper leathers were cut out of tanned calfskins and sewed together.
The leather for the soles was cut out of tanned ox or steer hide, the pieces being the insole, the outsole, and the lifts of the heel. The inner soles were made of softer leather. Sometimes split sole leathers were used for uppers. The shoemaker then softened the leather by steeping it in water, until it was pliable and at the same time firm, and would cut like cheese.
The insoles were attached to the bottom of a pair of wooden lasts, and the wet leather fastened on with lasting tacks so as to mold it to the last. When it was dry, the shoemaker with pincers drew the leather out until it had taken the exact form of the bottom of the last. Then he rounded the soles by paring down the edges close to the last, and formed around these edges a small channel or feather cut or slit about an eighth of an inch in the leather.
Next he pierced the insoles all around with a bent awl, which “bit” into, but not through, the leather, and came out at the channel or feather edge. The boots were then lasted by placing the uppers on the lasts, drawing the edges by means of pincers tightly round the edge of the insoles. Then they were fastened in portions with lasting tacks. Lasting was considered a very important operation, for unless the upper was drawn smoothly and equally over the last, leaving neither a crease nor wrinkle, the form would be a failure. A band of flexible leather about an inch wide, with one edge pared, was then placed in position around the sides of the shoes, up to the heel or seat, and the maker proceeded to “inseam,” by passing his awl through the holes, already made in the insole, catching with it the edge of the upper and the thin edge of the welt, and sewing all three together in one flat seam, with a waxed thread.