A turret was a small watch tower, incorporated into the curtain wall of Hadrian's Wall. The turrets were normally spaced at intervals of one third of a Roman mile (equivalent to ) between Milecastles, giving two Turrets between each Milecastle.
Numbering system and naming
In the numbering system introduced by John Collingwood Bruce in 1930, Turrets were numbered after the Milecastle located to the east of the turret. The nearest turret to the milecastle is suffixed by 'A', and the other turret by 'B'. For example, travelling west from Milecastle 33, the first Turret encountered would be Turret 33A, and the second would be Turret 33B. Both lower and upper case 'A' and 'B' suffixes are in widespread use, and the full name is often abbreviated to (for example) 'T33a'.
Many turrets also have a name, which is often shown in brackets following the number. For example, Brunton Turret is often referred to as 'Turret 26B (Brunton)'.
Turf Wall
Where the Turf Wall and Stone Walls diverge from one another (just to the east of Birdoswald), Milecastles and Turrets unique to the Turf Wall are given a 'TW' suffix, for example 'T50bTW'. A suffix of 'SW' may also be used to uniquely identify a turret as belonging to the 'Stone Wall'.
Cumbrian Coast
Although Hadrian's Wall itself ended (at its western terminus) just beyond the fort of Maia at the modern village of Bowness-on-Solway on the Cumbrian coast, the system of milecastles and turrets continued beyond this point, along the west coast as far as Flimby, with comparable spacing. However, the nomenclature adopted for the coastal Milecastle equivalent is 'Milefortlet', and the equivalent of the turret is here called a Tower. The numbering system adopted for the towers along the Cumbrian Coast is (for example) 'T21a CC' (the 'CC' suffix meaning 'Cumbrian Coast'), though the CC suffix is often not used if the reference is clear from the context, so care must be taken not to confuse (for example) 'T21a' meaning 'Turret 21a', and 'T21a' meaning 'Tower 21a'.
The first referenced tower is 'T0a CC' (just to the west of the Bowness on Solway), and the last is 'T25b CC'.
Construction
Plan
Turrets were constructed of mortared stone (the exception being Turret 19B, which used clay). They were built to a square plan, usually around 20 Roman feet along a side, which is equivalent to . Evidence suggests that the floors were originally clay (e.g. Turret 7B and Turret 10A), or clay and mortar (e.g. Turret 25B and Turret 26A). In many cases, later repairs to the floor had been made, either with stone (e.g. Turret 26A), or with flagstones (e.g. Turret 7B). Many turrets' floors had undergone subsequent (sometimes multiple) resurfacing, in some cases with sand (e.g. Turret 26A) and in some cases with flagstones (also Turret 26A). Turret 51B was found to have had straw as a floor covering, as had Tower 16B.
An access doorway was provided in the south wall (the east wall is the equivalent on the Cumbria Coast) of the turret, located either at the east or western end. These contained an outward opening door, above a stone threshold. Two threshold types have been identified: monolithic, or cut from a number of stones. Keys have been found at two of the towers along the Cumbrian Coast, but at no other turret.
The remains of hearths have been found in many turrets, though (unlike milecastles) no remains of ovens have been found. These were in no fixed position, and in some cases had been moved to different locations over time (e.g. Turret 10A), usually corresponding with a renewal of the floor. In at least one case (Turret 18B), the temperature at which the hearth had been operated, together with other finds at the site, suggested that the turret had been used as a workshop.
Several turrets have been identified that had paths leading to the door.
Variations: Stone Wall
On the stone wall, (in the same way as Milecastles,) additional structures known as Wing Walls were incorporated on the east and west side, allowing bonding to the curtain wall. This is interpreted as evidence that turrets (and milecastles) were constructed before the curtain wall. Where turrets were built with the intention of bonding to a broad gauge curtain wall, they were given broad wing walls. However, there are many cases where the curtain wall actually constructed was of narrow gauge, giving a point of reduction where the curtain wall and turret wing walls join. To facilitate bonding with the curtain wall, wing walls were constructed longer at the base, and stepping inwards as they were built upwards. Turrets thought to have been constructed later in the plan were built with much shorter wing walls.