When the buttonhole has been worked all around, the end is completed with a bar tack made by taking two or three stitches across the end of the buttonhole, drawing the edges closer together. This bar is covered with buttonhole stitches worked close together. The thread is fastened securely on the wrong side.
After very large buttonholes are finished, their straight edges should be closely basted together by an over and over stitch and then pressed under a damp cloth. Before they are dry, a bodkin or stiletto should be pushed vigorously up through each eyelet until that opening becomes perfectly round and the stitches on its edges are regular and distinct. When the basting is removed, the buttonhole will be symmetrical in appearance.
Buttonholes which are to bear a strain are cut in the direction of the pull, but sometimes they are cut in the opposite direction, as for a shirt waist. Such a buttonhole may be completed with a bar tack on each end.
Ordinary buttons should never be sewed down tightly, but the thread should be loose so that it may be wound around at the end, thus protecting the holding threads from wear. The shank prevents the buttonhole from being crowded out of shape. Loose sewing can most easily be done by placing a pin or needle across the top of the button and sewing over it. If a button is much concaved, the pin may be placed underneath. The pin is removed before winding.
In sewing on a four-hole button, the stitches should be made symmetrically, either parallel or crossed, but not both. If parallel or in a two-holed button the stitches should run in the line of the buttonhole. The thread should always be fastened at the beginning and at the end of the work. Place the knot upon the outside of the garment where it may be cut off when the button is sewed securely. The knot is sometimes placed under the button.
In sewing buttons on a cloak or coat an extra strip of canvas or silesia over the canvas interlining should be placed the entire length of the buttoning for strength. This should be applied before the work on the garment is too far advanced and if cut sufficiently wide, will allow any slight alteration. The sewing should go through the canvas facing and stay, but not through the under side or facing of the material.