“If I had the money to deposit for a Bible,” said Martin Duttlinger, “I could easily obtain one.”

“And the money we expect to furnish, of course,” said Faust. “No one can borrow so valuable a piece of property as a Bible, without the same as buying it.”

Gutenberg, and the Art of Printing — Part 76

It was accordingly arranged that Martin Duttlinger, who was the most trusty of their workmen, should be charged with the mission of buying a Bible of Trithemius, Abbot of Spanheim, who was known to have books for sale; and Martin was accordingly fitted off. After his departure, affairs went on with the firm much as usual, save that they felt the impulse which the resolve of engaging in the noblest enterprise on earth could not fail to give; and who can doubt that the smile of God’s countenance rested on them, lightening their toil?

Gutenberg, and the Art of Printing — Part 76

Gutenberg and Faust advised much together respecting the improved printing machine they were adjusting, and Schoeffer made rapid improvement in his particular branch of the art.

Gutenberg, and the Art of Printing — Part 76

Gutenberg’s press was very simple in construction,--a board acted on by a screw, like a cheese-press. On this board the type was placed inclosed in a frame, then inked; the paper was then laid over them, and the screw turned by a lever with the hand. In constructing this press, he had two upright posts of great strength, seven feet and a half high, placed four feet apart, and fastened together at the top and bottom by two stout crosspieces. In this frame an iron screw was made to work, by means of two parallel additional crosspieces, about a foot and a half apart, connecting the perpendicular posts. From about the middle of each of these upright posts, three feet from the floor, a slide projected, called a rib; these posts were parallel to each other, and firmly fitted, to bear a great weight. But these two points of the press,--the _screw_ and the _slide_,--let us see of what use they were. A table was made to run in under the frame and out, the slide supporting it in place of legs. The screw worked in a box, called a hose, by means of a bar or lever inserted in it; the toe, or lower end of the screw, working in a sort of cup fixed upon a large block of dense wood, having the face planed smooth, and called the platen. By turning down the bar, the screw forced down the platen, which was fastened to it, just as far as it descended; when the screw was raised, the platen was also raised.