Yacht, the miniature, and how to rig her, 331-352; miniature yacht regattas, 334; model of yacht, 335; making the hull, 336-337; how to cast and attach a lead keel, 337-338; the deck, 338; bowsprit and rudder, 339; mast and other spars, 340; standing rigging, 341-342; sails, 343; running rigging, 344-345; a schooner yacht, 345; spars and stays for a schooner yacht, 346-349; belaying, bolt ropes, reef-points, 350; painting the miniature yacht, 350-351; flags, 352
------------------------------------------------------------------------
This amusing little puppet is very easily constructed, and, like several other mechanical toys in this book, furnishes much entertainment for the little folks. Even the baby will sit in her high chair, half-hours together, watching the little man turning his crank, while she claps her tiny hands and crows at so delightful an exhibition of untiring energy.
Cut from cardboard a disc like Fig. 2, which shall measure about six inches across; then by means of a ruler draw the lines _a b c d_; half-way between these points make four others, corresponding to _e f g h_; and lastly, between all these, still another set of lines. Make the circle, _m_, one-and-a-half inches in diameter, and with a pair of sharp scissors cut through all these lines, to the edge of the smaller ring. Bend one edge of each of these triangular pieces slightly upward, as indicated by the shading, and the opposite edge downward; also bend a piece of wire a foot long, so as to form the crank indicated in the illustration.
Next make a frame-work for the figure to rest upon: this should consist of a three-cornered piece of wood, six inches long for the bottom, a stick six or seven inches long for the upright, and lastly, the support for the upper part of the wire, with a small hole in one end for the latter to pass through. Fasten these pieces together with small brad-nails, and secure the upright to the bottom piece by a screw or nail passing up from below. The wire, having the crank already bent in the proper place, may now be passed up through the hole, and the other end sunk down into another, bored a short distance into the bottom board, directly below the upper one. Then the wire may be fastened to the windmill, by passing it through a little one side, then back again through on the other side of the center; twisting the end once or twice about the main stem beneath the windmill; it now turns with the windmill, and it is needless to say that the friction in the holes should be as slight as possible.