Hides should lie in the pack and salt for 25 to 30 days, so as to be fully cured and ready for shipment.
Before the hides are salted the switches should be cut off of the tail and all loose ends of the hide should be cut off. The butt of the ears should also be split; if the hides go into the pack without attention to this point, it makes the pack very uneven on account of the thickness of the ear, and the salt does not have a chance to properly penetrate the ears, and they are liable to spoil. Loose pieces of meat that are carelessly left on the hides and all excessive fat should be trimmed off. Hides must not be salted until five hours or longer after the animal is killed, and they must not be piled closely, as this would prevent the animal heat from escaping. If hides are salted with the animal heat in them, very often the hair will slip, which will make No. 2 hides.
Switches should be spread out on the floor so they will thoroughly cool off. After they are thoroughly cool, they can be piled into a heap and salt applied so they are entirely covered. The more salt put over them the better, as they spoil very easily.
Butchers can easily tan the skins of Sheep, Goats, Cattle and Calves with Tanaline, and they can often pick up fine skins of wild animals, which can also be easily tanned. By tanning the fancy skins that the Butcher frequently can get, he can sell them for three or four times as much as he would realize when sold to the Hide Buyer.
First:--After weighing the skins, soak them in plain cold water; fresh or salted skins for 24 hours, and air dried skins for at least 48 hours. Then scrape off all the fat with a dull instrument, such as a putty knife or sharp piece of hard wood. Then wash thoroughly, with cold water, both sides of the skin.
Second:--Use, for every 30 pounds of skins, a 2-pound package of Tanaline and 4 pounds of salt. Dissolve 2 pounds of Tanaline and 4 pounds of salt in 5 to 6 gallons of cold water, and when thoroughly dissolved, place the skins into it. Have sufficient water so that all the skins are entirely covered. Tan small, thin skins in this solution for 24 hours. Goat, sheep, calf and dog skins should be allowed to tan from two to three days, according to their thickness. Cattle or horse skins, or skins of a similar nature, require one week in this solution to properly tan them. During the tanning process remove the skins and replace them in the same solution twice a day, so that the solution gets over all parts of the skins uniformly. After tanning, drain off all the solution that can easily be drained off, and spread the skins out with the flesh side up, away from the sun.
