(186) The rollers and clearers are ground after removal from their places in the machine. A machine of which Fig. 110 is a perspective view is employed for this purpose, this being the type made by Messrs. Dronsfield Brothers, who have specially devoted themselves to this class of machines. The machine consists of a frame which has bearings formed, in which the shaft of the grinding roller revolves. Affixed to the lower portion of the frame is a counter shaft from pulleys, on which the emery roller is driven at a speed of 300 revolutions per minute. The roller to be ground is borne by the two bearings shown, which are slid laterally by the extremities of arms secured to a transverse spindle sustained by brackets fixed to the framing. The two arms are moved to or from the frame by means of a hand wheel which is keyed on a short spindle, on which is also fixed a worm. This engages with a quadrant fastened on the transverse spindle, so that the rotation of the worm in either direction gives a movement to or from the grinding roller. In this way the card roller is brought into contact with the grinding roller equally over its whole surface, the axis of the bearings in the arms being always parallel with those of the grinding roller. A bonnet is placed above the machine, and the dust is removed by the small centrifugal fan shown. The card roller is driven by a separate strap from the counter shaft.

(187) The flats of self-stripping machines are removed from the latter, and are secured on suitable bearings formed on the frames of a special grinding machine. The bearings are adjustable, so that the correct position is given to the flat during grinding. The faces of the flats when so held are moved across the grinding roller, which revolves at a high speed. As the arrangement is a very simple one, and does not present any great novelty, it is not necessary to describe it in great detail.

Modern Cotton Spinning Machinery — Part 88

(188) As the wire clothing on the cylinder, doffer, rollers, and flats becomes filled with motes, neps, and short fibres, it is necessary to remove these periodically. This operation is called “stripping,” and it is a very important one. Whatever may be said to the contrary, stripping cannot be dispensed with unless some specific be found for the removal of the impurities as fast as they are taken out of the cotton. The plan formerly adopted for this purpose has fallen into disuse, as it implied the stripping of the card during work, and led to the mixing of the stripping with the finished sliver. It has been shown that a clean wire surface is the best for carding, and it will be easily seen that the filling of the spaces between the teeth will materially reduce the elasticity of the wires. Regular stripping is for this reason advisable; but the ease with which, if so carried out, the dirt can be removed, constitutes a further reason for this procedure. Carding speedily becomes poor in quality unless this is looked to, and all spinners should carefully watch this point. Another matter is, that inasmuch as it is practically impossible to strip all the cards simultaneously, the operation should be effected so that there should be an equal proportion of clean and dirty or half dirty machines. These are all little points, but they are of great importance in the effective working of a machine.

Modern Cotton Spinning Machinery — Part 88