_Stoppers_ for ordinary running ropes are made by splicing a piece of rope to a bolt or to a hook and thimble, unlaying 3 or 4 ft., tapering it by cutting away some of the yarns, and marling it down securely, with a good whipping also on the end. It is used by taking a half-hitch round the rope which is to be hauled upon, dogging the end up in the lay and holding it by hand. The rope can come through it when hauled, but cannot go back.
_Whipping and Pointing._--The end of every working rope should at least be whipped to prevent it fagging out; in ships of war and yachts they are invariably pointed. Whipping is done by placing the end of a piece of twine or knittle-stuff on a rope about an inch from the end, taking three or four turns taut over it (working towards the end); the twine is then laid on the rope again lengthways contrary to the first, leaving a slack bight of twine; and taut turns are repeatedly passed round the rope, over the first end and over the bight, till there are in all six to ten turns; then haul the bight taut through between the turns and cut it close. To point a rope, place a good whipping a few inches from the end, according to size; open out the end entirely; select all the outer yarns and twist them into knittles either singly or two or three together; scrape down and taper the central part, marling it firmly. Turn every alternate knittle and secure the remainder down by a turn of twine or a smooth yarn hitched close up, which acts as the weft in weaving. The knittles are then reversed and another turn of the weft taken, and this is continued till far enough to look well. At the last turn the ends of the knittles which are laid back are led forward over and under the weft and hauled through tightly, making it present a circle of small bights, level with which the core is cut off smoothly. Hawsers and large ropes have a becket formed in their ends during the process of pointing. A piece of 1 to 1½ in. rope about 1½ to 2 ft. long is spliced into the core by each end while it is open: from four to seven yarns (equal to a strand) are taken at a time and twisted up; open the ends of the becket only sufficient to marry them close in; turn in the twisted yarns between the strands (as splicing) three times, and stop it above and below. Both ends are treated alike; when the pointing is completed a loop a few inches in length will protrude from the end of the rope, which is very useful for reeving it. A hauling line or reeving line should only be rove through the becket as a fair lead. _Grafting_ is very similar to pointing, and frequently done the whole length of a rope, as a side-rope. Pieces of white line more than double the length of the rope, sufficient in number to encircle it, are made up in hanks called foxes; the centre of each is made fast by twine and the weaving process continued as in pointing. Block-strops are sometimes so covered; but, as it causes decay, a small wove mat which can be taken off occasionally is preferable.