There are ten building berths ranging in length up to 700 ft.; but slight alterations would enable the firm to build vessels of still greater size. Several of these are shown on the engraving on Plate XXXVII., facing page 88. The launching ground is probably the finest in the river, the channel being here of great depth and very wide, as is shown on the engraving opposite. Indeed, ordinary merchant vessels with full lines are launched without any check chains; the fine-ended ships--mail steamers and cruisers--are, as a precautionary measure, checked by drags in the usual way. The engraving on Plate XXXVIII., facing page 90, shows the launch of H.M.S. _Argyll_.
[Illustration: Plate XLIV. THE FITTING-OUT DOCK.]
[Illustration: Plate XLV. THE GRAVING DOCK.]
The ships launched are completed in the fitting-out dock, constructed about two years ago, and illustrated on Plate XLIV. The engraving shows H.M.S. _Argyll_ under the big jib-crane. This dock has a length of 560 ft. and a width of 172 ft., and opens directly into the channel of the Clyde. The depth of water is never less than 28 ft., so that warships are afloat at all states of the tide. A prominent feature in the view is the crane, which was supplied by Messrs. George Russell and Co., Limited, of Motherwell, and lifts 120 tons at a radius of 70 ft. It is carried on concrete foundations and piers, which rise 20 ft. above the level of the quay. In addition to the pier for carrying the mast of the crane, there are similar supports for each of the back legs through which the crane is anchored.
One advantage of the derrick type is that the crane may be placed close to the edge of the quay; in this case the centre is only 7 ft. from the front of the wharf, so that the full load of 120 tons can be dealt with at an effective outreach of 63 ft. from the quay. The maximum radius of the heavy purchase with a load of over 60 tons is 90 ft., and of the light purchase gear, with a load of 10 tons, 98 ft. The minimum radius of the crane is 25 ft. There are four sets of gear: for lifting heavy loads, for raising light weights, for derricking the jib, and for slewing; a separate controller of the enclosed tramway type is provided for each. The main hoisting and derricking motors are of 50 horse-power, and the others of 35 horse-power. The speed of hoisting 120 tons is 5 ft. per minute, while a 10-ton load is raised at the rate of 40 ft. per minute. Automatic brakes are fitted for the slewing motion, and powerful hand-brakes for the hoisting and derricking gears. All motions are controlled by one man in the steelhouse fixed to the mast of the crane 56 ft. above the quay level.