In addition, there must be mentioned here a compound which formerly found extensive use in fur dyeing. This is a double salt of copper and iron, analogous to alum, ferrous copper sulphate, known as blue salt. It is very seldom used at the present time, being more effectively replaced by other substances.
The typical chromium mordant is chrome alum, which is a potassium or ammonium chromium sulphate, constituted just like the aluminum alums, and forming crystals like these. More frequently used, nevertheless, than the chrome alum, is chromium acetate, which is prepared from it, either by treating a solution of the chrome alum with a solution of lead acetate, or in the following manner:
50 grams of chrome alum are dissolved in 500 cubic centimeters of boiling water. To this is added 15 grams of 20% ammonia, diluted with 15 grams of water.
The precipitate which forms is filtered off, and preserved, the filtrate being discarded. After thoroughly washing the residue on the filter it is dissolved in dilute acetic acid, heating if necessary, to effect solution.
Other chromium compounds of an entirely different type are also used in fur dyeing, these being chromates and bichromates, the latter finding greater application than the former. Sodium bichromate is the salt most usually employed. This forms orange-red crystals which are very soluble in water, and in addition to its use as a mordant it also serves as an oxidizing agent for developing or fixing certain dyes on furs.
Compounds of tin find only limited application in fur-dyeing, the only one of importance being tin salts, stannous chloride, which occurs in the form of white, hygroscopic crystals, which must be preserved in closed vessels. It is very soluble, but in dilute solutions it readily forms a basic salt, so stannous chloride is usually used in very concentrated solutions.
After the furs have been treated with the solution of some alkali for the purpose of killing the hair, they are always passed through a slightly acidulated bath to remove any alkali which may still be adhering. This operation must always be gone through before the skins can be mordanted or dyed, for if it were neglected, very uneven and uncertain results would be obtained. This process, however, entails the expenditure of no small amount of time, labor and chemicals when large lots of skins are being handled. In order to eliminate this extra step of "souring" between killing and mordanting or dyeing, it has been proposed to use alkaline mordants which combine the killing and mordanting functions, and accomplish these two processes at the same time. The advantages of employing such mordants are easily apparent. Cumbersome manipulation and handling of the skins, with the attendant consumption of much time and labor are reduced to a minimum, and besides there is no needless waste of chemicals as is the case in the ordinary methods of killing the furs.