_After opening the gauge cocks_ to ascertain the height of water in the boiler, they should be closed tightly to prevent leakage.
_It may have been discovered_ that when gauge cocks are closed after being blown out, they leak badly; this is often due to the fact that mud or sand has become attached to the seat of the valve. The easiest way to remedy this difficulty is to open the cocks and let them blow out for some time, as the friction of the water in its escape will in all probability remove the obstacle.
_Glass water gauges_ may be cleansed by removing the glass; then tying a piece of cotton waste or lamp wicking to a splint of wood, applying soap or acetic acid, and passing it through the inside of the tube; then replace the glass, and when steam is raised close the lower valve, open the drip cock, and the steam blowing through will wash the glass perfectly.
_To cut a glass gauge tube._—If a glass gauge is too long, take a three-cornered file and wet it, hold the tube in the left hand with the thumb and fore-finger at the place where you wish to cut, saw it quickly and lightly two or three times with the edge of the file, and it will mark the glass. Now, take the tube in both hands, both thumbs being on opposite sides of the mark and about an inch apart, then try to bend the glass, using your thumbs as fulcrums and it will break at the mark which has weakened the tube.
_Never touch_ the inside of the water gauge glass with iron or wire, as while the glass may be cut on the outside with a file, the slightest touch of steel or iron on the inside will cause an abrasion, the result of which is that the glass will crack and become useless.
_Water gauge glasses_ frequently break because the steam and water connections are not in line, because the stuffing boxes are screwed down too tight, and sometimes in cold weather when struck by a cold draught of air admitted through an open door or window.
_An engineer or fireman should_ never fill a boiler with cold water while the boiler is hot, as the injurious effect produced by contraction is similar to that produced by blowing out at a high pressure, and if persisted in will result in permanent injury to the boiler.
_Exhaust steam will heat_ water to 212° Fahr. under atmospheric pressure.