A rubber-handled socket should be used for safety and to withstand hard knocks. It should have a switch on it, preferably a push switch in a recess in the handle.

The connector or attachment plug should be of rubber or solid plastic and have a metal cord grip fastened to it. This grip will hold the cord firmly and prevent strain on the terminal connections.

Electricity for the 4-H Scientist — Part 14

Get a good lamp guard. If the wire is too light, it may bend and break the bulb when hit or dropped. For the lamp itself, get a rough service lamp. An ordinary lamp won't last long with rough usage.

Electricity for the 4-H Scientist — Part 14

Your 4-H electrician's kit or screwdriver, knife and soldering iron

Electricity for the 4-H Scientist — Part 14

1. About 20 feet of 2-wire, No. 16 heavy duty (hard service)

2. A rubber-handled socket with switch and a side outlet

4. A good connector plug cap, preferably with a clamp-type grip for the cord

1. Remove about 2 inches of the outer covering of cord at one end.

2. Separate the wires and cut away the filler material.

3. Remove 3/4 inch of the conductor insulation from the end of each wire and tightly twist the strands together to form a firm conductor. Be careful not to cut any of the fine wires. Ends may be soldered.

4. Slide the plug in position on the cord.

5. If there is no cord grip, tie the underwriters' knot (Figure 1). If there isn't room enough, make an "S" loop by passing the wires around the prongs before fastening them to the terminal screws as explained in the next step.

6. Loop the bare part of the wire around the screw in the direction the screw is turned to tighten (clockwise direction). This will prevent the wires from being forced out from under the head of the screw as it is tightened. Now repeat with the second wire, wrapping it around the other prong of the plug.

1. Separate the parts of rubber-handled socket (Figure 2).

2. Prepare the other end of the cord as in steps 1, 2, and 3 above.

3. Insert the cord through the rubber handle and socket guard.

4. Tie the holding knot (underwriters' knot) as explained in Step 5.

5. Connect wires to terminal screws and assemble the rubber-handled socket.

6. Screw in the rough service lamp and test your cord.

7. Put the shielded lamp guard on the socket and tighten the holding clamp until it is firmly in place. You are now ready to use or demonstrate your trouble light.