(117) There are one or two things to notice in respect to the operations just described. The first is, that all the faces are formed from that on which the wire clothing is subsequently placed, and that consequently the flat when traversing is provided with working surfaces which ensure it being parallel to the cylinder all across, provided the bends are correctly set. This is, as will be seen, an important point. Again, the whole of the surfaces to which the chains are attached are true with the flat ends, so that there is no tendency to pull the flat askew. Having thus constructed, by the means indicated, the flat as perfect as is possible by machine, it is necessary to put the “heel” in, and also to correct any twist which may have arisen by the spring of the flat whilst being milled. There are two methods of testing this point, one mechanical and the other electrical. As will have been noticed from the description of the method of milling the flats, two parallel surfaces are formed at the upper and lower side of each end of the flat. It will be evident that, if the flat is placed upon either of these surfaces and tested by a suitable apparatus, the other surface should be as nearly as possible parallel with the first. In order to see that this is so, the flat is placed face downwards on two steel faces perfectly parallel with each other. At each end of the table carrying these faces is an indicating apparatus consisting of a graduated scale and two pairs of compound levers, so arranged that a slight inaccuracy is multiplied to a large extent. If, therefore, the flat is laid on the blocks and the points of the levers are allowed to fall on the four surfaces left after the flat is milled by the long and short radius machines, the setter can see at a glance if the surfaces are accurately formed. In practice, the two ridges or surfaces at the front of the flat—that is, the edge nearest to the doffer end of the card—are reduced somewhat by hand, thus throwing up the back edge. This is what is known as giving the “heel” to the flat, and its object is to leave a slight space between the wire points of the flats and cylinder at the back of the flat, while at the front these are as close as possible together without touching. The object of this is to prevent a rolling up of the strippings and cotton fibre, which has been found to exist where the wire at the back or “toe” of the flat nearly approached that of the cylinder. The heel having been given the flat is then tested by the apparatus described, but instead of all the fingers corresponding, this only occurs with the two which are in contact with the same surfaces on each edge of the flat. One pair registers the variation caused by the heel and should correspond, while the other pair registers the position of the untouched surface and must also correspond. This device is the one most commonly used, and gives very accurate results. Messrs. Howard and Bullough adopt an electrical test which is also said to give good results. Similar devices are used in some cases to set the bends accurately with the cylinders; in others a simple scriber or pointer being used and set down, so that a small slip of steel can be easily moved across the bend under its point. As the latter is carried in a bracket fixed to the cylinder the bend can easily be tested all round. Messrs. Howard and Bullough use an electrical scriber, contact with which rings a bell, and thus indicates the point requiring adjustment. The use of the graduated indicators as shown in Fig. 60 enables this to be easily made, and delicacy of adjustment attained.
Oceans Report
Modern Cotton Spinning Machinery — Part 50
Tags