(94) It is of extreme importance to produce laps at an early stage, as they play a great part in effective spinning. Before dealing with this point a few words may be said about the necessity for care in feeding the cotton. The fibre is easily ruptured, more especially at the points, which, owing to their distance from the seed during growth, are often solid. It is conceivable that the cotton might be fed at precisely the same speed as that of the periphery of the beater blades. In that case it would simply pass through the machine without any treatment whatsoever. Or it might be fed so rapidly that the beater in its rotation would knock it off the end of the lap in tufts or lumps. As the blow of the beater is given transversely of the fibre, such a treatment would produce a large amount of broken fibre. It is, therefore, of importance to feed so that the cotton is neither broken by overfeeding or pulverised by underfeeding, and in fixing the right velocity the length of the fibre requires carefully taking into account. The conditions of successful and economical work are well known, and may be stated as follows: The blow given must be sharp, and not dragging; the beater blades must be shaped to detach, without rupturing, the fibres; the rate of the feed roller must be regulated to insure the thorough detachment of the material; and, finally, the cotton should not be struck from a sharply angular surface. It is, of course, impossible so long as revolving beaters are used to avoid bending the fibres, but it is quite possible to so shape the surface from which they are struck as to minimise the risk of damage.
(95) The various illustrations given of both opening and scutching machines show that it is the practice to form the cotton at as early a stage as possible into a lap. Not only is this course more convenient, but it is decidedly preferable where good work is required. In cases where it is the custom to eject the cotton from the opener in its opened condition, it is necessary to lay it on the feed lattice of the scutcher, either manually or by means of a lattice. A practice which is now almost obsolete is to weigh the cotton by means of scales adjoining the feed apron, and spread it on the latter by hand. Even with expert attendants, the risk of uneven feeding by this plan is great, and uneven feeding means unevenly-weighted laps as a result. By the exercise of a little care, and more especially if the piano-feed be fitted to the opener, a lap it produced on that machine the inequalities of which are much reduced. The author recently saw a lap, paragraph 52, produced on the combined feed, opener, and scutcher of Messrs. Platt, which was the first made on the particular machine employed, and which was remarkably regular in thickness. The same result has been seen in other cases, and by obtaining a regular sheet at this early stage many advantages arise. Whether an opener be employed in conjunction with a breaker scutcher or not, the formation of a lap is a great help to good work. Where such a combination exists, it is customary to fit pedal regulators immediately before the scutcher beater is reached, so that the inequalities existing in the sheet as it is taken from the first pair of cages are at once corrected. A reference to Figs. 10 and 20 will show this application fitted respectively to the opener feed and the scutcher beater.