The next day, the 5th, we made fast to the landing-place of Mswata. The Major and Dr. Parke had arrived four days previously. They had prepared quantities of fuel, and had purchased a large pile of provisions--loaves of bread from the manioc root and Indian corn.
On the 6th the Major and his companions received orders to march their men to Kwamouth, and await the steamer. The _Stanley_ was ordered to proceed to Bolobo, debark her passengers, and descend to Kwamouth to convey Barttelot and men, while we reorganized companies at Bolobo.
On the 7th we observed the _Stanley_ steamer ashore on the left bank near Chumbiri, and proceeding to her to inquire into the delay discovered that she was badly injured by running on a rocky reef. The second section had been pierced in four separate places and several rivets knocked out and others loosened. We therefore set to with the engineers of all the other steamers to repair her, but Messrs. Charters and Walker, both Scotchmen, were the most effective at the repairs. We cut up some old sheet iron oil drums, formed plates of them, and screwed them in from the outside. This was a very delicate labour, requiring patience and nicety of touch, as there were two feet of water in the hold, and the screws required to be felt to place the nuts on, as well as the punching of holes through the bottom of the steamer. The engineer was up to his waist in water, and striking his chisel through an element that broke the blow, then there was the preparation of the plate to correspond with the holes in the steamer, spreading the minium, then a layer of canvas, and another layer of minium. When everything was ready for fixing the iron plate, a diver was sent down, the iron plate with its canvas patch and minium layers in one hand, and the end of a string attached to a hole in the plate in the other hand. The diver outside had to feel for the corresponding hole in the steamer, and the engineer up to his hips in water within the hold felt for the end of the twine, which when found, was drawn in gently, and the plate carefully guided, or the bolt was slipped in, and the engineer placed the nut on. For hours this tedious work went on, and by evening of the 7th, one large rent in the steel hull had been repaired; the 8th and 9th were passed before the steamer was able to continue her voyage.