Drain tile has been of major importance in the development of the state. Early settlers found many low lying, swampy areas and tracts of land that drained poorly after heavy rains. Ditches were dug to carry away the water from some areas, but others were drained by means of drain tile—pieces of fired clay pipe several inches in diameter and about a foot long that were laid end to end in trenches below plough depth and then covered with earth. Water seeped into the tile, which discharged it into ditches. Tile factories, built throughout Illinois near clay or shale deposits, did an active business. Gradually, however, as more and more farm land was drained the demand slackened and many tile factories went out of business. Although there are fewer factories, much drain tile is still manufactured in Illinois.

Many of the early tile plants also made bricks to be used for making foundations, buildings, sidewalks, and other structures. The bricks were made by hand-operated equipment. Some of the old hand-molded bricks may still be seen in older buildings. Now the brick-making process is highly mechanized and even though there are fewer plants they produce more bricks.

Industrial Minerals and Metals of Illinois — Part 24

Illinois shales are a part of the bedrock—that is, they are associated with indurated rocks such as sandstone and limestone. Most clays are surficial rocks occurring in deposits near the surface, where they lie above the bedrock. Exceptions are certain clays found in extreme southern Illinois and the underclays, also called fireclays, that occur beneath coal seams and are part of the bedrock.

Industrial Minerals and Metals of Illinois — Part 24

The surficial clays are of two principal kinds—till and loess. Till is a deposit left by glaciers. It is a gray, blue-gray, or brown clay containing varying amounts of sand, pebbles, cobbles, and even boulders. Till is found at many places in the state and is used for brick making, especially in the Chicago area.

Industrial Minerals and Metals of Illinois — Part 24

Loess is a wind-deposited silty clay or clayey silt and is found in many parts of Illinois. It is thickest on or near the bluffs of the Mississippi, Illinois, and Ohio Rivers. It generally is brown and stands in steep faces in roadcuts and other excavations. It once was widely used for making brick and tile.

Of major importance in making clay products in Illinois are the bedrock shales and the clays associated with the coal-bearing rocks that underlie much of the state. The shales, and the clays to a lesser extent, are dug at many places for making structural clay products such as bricks, structural tile, and drain tile. They also are used to make lightweight aggregate for concrete. The underclays of some of the older coal seams are used to make buff-colored brick, stoneware, and a highly heat-resistant brick (firebrick) that is used in industrial furnaces or in other operations involving high temperatures. Some fireclay, ground as fine as flour, is added to molding sand to make it coherent enough to form into molds for metal casting. Sewer pipe and flue lining also are made from underclays.