When the entire edition is to be bound with a permanent cover, provision is made for three-sixteenths of an inch trim at the head. This enables the printer to standardize forms without varying the head margins, and gives the binder sufficient margin to trim inaccurately folded sheets.
To trim books on a cutting machine, take as many as will make a pile about three inches high, and jog at the head and back. Set the back gage the exact size to which the book is to be trimmed; put the books in the machine with the head against the side and the back against the back gage. Run down the clamp, provided the machine has a hand clamp; an automatic or self-clamp requires nothing more than to pull the lever. When the cut has been made and the machine stops, remove the books and put to one side. Repeat this operation until all books are trimmed on the fore-edge and lay aside in piles with the backs out.
To trim the heads and tails, fillers must be made to take up the thickness of the back. Cut strips of straw or binders' board about four inches wide; glue them together; fan out and press. Put the books in the machine with the heads against the back gage and the trimmed fore-edges against the side; then lay the board filler on top in such a way that the fanned-out ends are sufficiently away from the back to permit an even pressure of the clamp on the books. Pull the lever, and repeat the operation for subsequent books. The filler can be glued to the clamp and the books put directly under it.
For the head, the gage is set forward and the trimmed tail is placed against the back and side gage. The board filler is placed on top in the same manner as above described and the operation continued. On thin books the board filler may be dispensed with by reversing the backs of the books alternately, so as to distribute the thickness of the back on both sides of the pile.
If there are two splits in the back gage, _i.e._, if it is a three-part back gage, set the center for trimming the fore-edge, the left for trimming the tail, and the right end for the head. This, however, should be done only when the quantity to be trimmed justifies it. When the back gage is set, tighten the thumbscrew with the hand. To guard against the marking of the book by the pressure of the clamp, cut a piece of binders' board somewhat larger than the width of the clamp face and glue it on the clamp.