A. A boiler should not be filled under any circumstances until it is about the same temperature as the water used to fill it.
Q. How are the hand-hole plates put back in position?
A. The plate that covers the hole is put on the inside of the boiler and held in position against the plate by a bolt attached to it and passing out through a yoke which straddles the hole upon the outside and serves as a brace against which the bolt acts.
A. By placing packing between the hand-hole plate and the boiler plate.
Q. What is the best kind of packing to use for this purpose?
A. Two or three ply sheet rubber is the best, cut in the form of a ring to fit the bearing surface of the plate.
A. Yes, hemp or cotton packing. When this is used it should be pulled out in fine shreds and thoroughly oiled before putting in position. Use as little as possible.
A. Yes, all the old packing that may have burned on the metal should be thoroughly scraped off, also the scale should be removed from the vicinity so that the packing will have a smooth and even surface to bear against.
Q. How are man-hole plates put in position?
A. In the same manner as the hand-hole plates.
Q. What is required of an engineer or fireman in the care of a boiler?
A. He should watch carefully all the parts that are exposed to any steam and see that they do not become unduly weakened by corrosion or accident. All the working parts and fittings should be examined daily and be repaired or replaced as soon as they show signs of wear or weakness. The steam gauge and safety valve should receive constant care and both should be tested frequently, the one by the other, and the steam gauge by a standard in order that it may be known to be in perfect order. When scale forming water is used the feed pipe should be frequently uncoupled and examined and all sediment removed. The check valve should be examined frequently to see that it seats properly so that water cannot leak from boiler in this way and the utmost care should be taken in regard to the consumption of fuel.
Q. In case of accident how should an engineer conduct himself?
Q. If the water gauge glass breaks, what should be done?
A. The upper and lower gauge valves should be closed immediately.