"Objects which are much decayed or cracked should, when cleaned and thoroughly dry, be again placed into linseed oil which has been slightly warmed and should remain therein for a few days before being smoked. Upon removal from this second oil bath they should be lightly wiped and dried over a moderately warm stove or in the sun. Patience is necessary, and nothing further should be done until the oil has entirely dried in the fine cracks and crevices and firmly binds the mass. The oil crust on the surface is then loosened by soaking in a strong soda solution and wiped off, after which the object is dried, smoked over the candle flame, and the soot wiped or brushed off with a soft brush. The smoking and wiping may be repeated if necessary."
Herr Straberger states that his treatment has been successful when impregnation with isinglass and coating with shellac has failed.
The methods of Hartwich and Jacobi hold an intermediate place between the above methods and those which will be subsequently explained. With the former they have this in common that they do not call for the entire removal of the rust and that they require the use of linseed oil; on the other hand their application presupposes the existence of a strong metallic core, otherwise when the rust is removed they will show merely a skeleton of the original object. The existence of a sufficiently substantial metallic core can be easily ascertained from the weight, for an object, which consists solely or in great part of the oxide of a metal, is much lighter than one of the same size which is largely metal. The ring also affords a test, for an iron object, of which the greatest part is metallic iron, gives a clearer note when struck than one which is chiefly rust. A still more certain test is the use of a file or a drill (comp. page 107).
HARTWICH'S METHOD[120]. This method is intended for objects of an especially large size, the hard oxide coating of which does not allow satisfactory steeping. Hartwich heats the object to redness, allows it to cool slowly, and then scrapes off the outer layer which has been rendered friable by this treatment. The subsequent procedure is that of Krause's method, viz. warming in linseed varnish.