(3) X. inquires: What is the rule for making a counterbalanced face wheel for engines? A. It is a common practice to place the counter weight directly opposite the crank, with its center of gravity at the same distance from the center of the shaft as the center of the crank pin, making its weight equal to weight of piston, piston rod, crosshead, and crank pin, plus half the weight of the connecting rod.
(4) A. R. asks: What is the best way to remove cinders from the eye? A. A small camel's hair brush dipped in water and passed over the ball of the eye on raising the lid. The operation requires no skill, takes but a moment, and instantly removes any cinder or particle of dust or dirt without inflaming the eye.
(5) D. F. H. asks: Can I move a piston in a half inch glass tube by the expansion of mercury? A. Yes, but you will require a long tube to get any appreciable motion of the piston.
(6) J. W. asks: What size of a bore and what length of a stroke I would want for a rocking valve engine of half a horse power? A. About 2 inches cylinder and 3 inch stroke, depending upon pressure and velocity.
(7) R. W. H. writes: In a recent discussion on hot air and steam portable engines it was decided to ask your opinion, which should be final. Water is scarce, though enough to use steam is easily procured. The country is hilly, so that lightness is desirable. The power wanted is 6 horse, and movable, that is, on wheels. Which will be best, hot air engine or steam engine? Which consumes most coal for a given power? Which will be cheapest in above case? A. For small powers the hot air engine is most economical, but we do not think it adapted to your purpose. We would recommend the steam engine for a portable power.
(8) J. C. T. writes: 1. I have a water tank for supplying my boiler, which is made of No. 22 galvanized iron; size 30 inches by 9 feet 4 inches. How many gallons will it hold? A. 342 gallons. 2. Will it be better to have it painted inside? A. Yes. 3. How many years will the tank wear under favorable circumstances, using well water? A. Depends upon the care taken of it.
(9) W. H. C. asks: Is there any way of deadening the noise of machinery overhead from the engine room below? The noise comes from machinery in the weave room of an alpaca mill. A. This is generally accomplished by setting the legs of the machines on thick pieces of India-rubber or other non-conductor of sound.