“Statement of the quantity of Yarn produced on Messrs. Sharp, Roberts & Co.’s self-acting mules in twelve working hours, including the usual stoppages connected with spinning, estimated on the average of upwards of 20 mills:—
No. of hanks per spindle. No. of yarn. Twist. Weft. 16’s 4-1/2 4-7/8 24’s 4-1/4 4-5/8 32’s 4 4-3/8 40’s 3-3/4 4-1/8”
This statement is dated December 23rd, 1834, so that it may fairly serve as a basis of comparison, assuming the number of turns of yarn to be in each case the same. Testing the advance by taking the production of 32’s, as stated above, the amount spun per spindle in a working week of 50-1/2 hours—its present duration—would be 18-2/3 hanks. Mules at that period were only made 400 to 500 spindles long. To-day they contain over 1,200 spindles, and produce of 32’s 32-1/2 hanks per spindle. This is an increase of 60 per cent.
(5) The increase of production has not, however, required a larger number of workpeople to obtain. On the other hand, fewer persons are needed to attend to the long mules named than were formerly required for less than half the number of spindles. The effect of this is seen in the decreased margin between cotton and yarns, which is very striking. The average price of 30’s twist yarn in 1832 is stated in Dr. Ure to be 12·7d. per lb., and of cotton 7·1d., leaving a margin of 5·6d. At the time of writing the price of 32’s twist is 8-11/16d., and of cotton 6-9/16d. per lb., leaving a margin of 2-1/8d. These figures are based upon the assumption that American cotton of middling quality is used in each case. Thus the price of yarn is much less, while that of cotton is little reduced. It is true that a margin of 2-1/8d. is barely sufficient to permit of a profit being made, but 1/8d. per lb. added will do 80, and a margin of 2-1/2d. is considered a large one in these days.
(6) This reduction in the cost of production has not been brought about by any diminution in the wages of the operatives, as could very clearly be shown if it were necessary. Nor is it the result of a lessened cost of erection. A spinning mill of 40,000 spindles, which in 1835 would be looked upon as a large one, cost, at that time, from 24 to 26 shillings per spindle to erect, including the buildings and accessories. At the present time mills are built to contain as many as 110,000 spindles, and these are filled ready for work at a cost not exceeding 21 shillings per spindle, the apportionment of which is as follows: The machinery costs nine shillings, the buildings eight shillings, and the engines, boilers, furnishings, and all accessories four shillings per spindle. Considering the great increase in the productive power of the machinery, the fact that it is so much less expensive to work, and that each machine is of much greater capacity, the figures given show that the tendency towards diminished cost is owing very largely to the efforts of machine makers.