[Illustration: Courtesy of the "Scientific American"
FIG. 22. How the mine automatically adjusts itself to various depths of water]
The operation of the mine is shown in Fig. 22. When it is thrown overboard (1) it immediately turns over so that the buoyant mine _A_ floats on the surface (2). While the anchor is slowly filling and sinking, the plummet _B_ runs out (3). If the mines are to float at a depth of, say, ten feet, this cord must be ten feet long. As soon as it runs out to its full length (4) it springs a latch, _C_, releasing the mine _A_. Then the mine cable _D_ pays out, as the anchor _E_ sinks, until the plummet _B_ strikes bottom (5). As soon as the plummet cord slackens a spring-pressed pawl is released and locks the mine-cable reel, so that as the anchor continues to sink it draws the mine down with it, until it touches bottom (6), and as the anchor was ten feet from the bottom when the plummet touched bottom and locked the reel, the mine must necessarily be dragged down to a depth of ten feet below the surface.
The mine itself, or the "devil's egg" as it is called, is usually a big buoyant sphere of metal filled with TNT or some other powerful explosive; and projecting from it are a number of very fragile prongs which if broken or even cracked will set off the mine. There is a safety-lever or pin that makes the mine harmless when it is being handled, and this must be withdrawn just before the mine is to be launched. In some mines the prongs are little plungers that are withdrawn into the mine-shell and held by a cement which softens after the mine is submerged and lets the plungers spring out. When the plungers are broken, water enters and, coming in contact with certain chemicals, produces enough heat to set off a cartridge which fires the mine.
The enemy mine-fields were often located by seaplanes and then mine-sweepers had to undertake the extremely hazardous task of raising the mines or destroying them. If they were of the offensive type, it was much better to destroy them. But occasionally, when conditions permitted, mine-sweepers undertook to raise the mines and reclaim them for future use against the enemy. The work of seizing a mine and making it fast to the hoisting-cable of the mine-sweeper was usually done from a small rowboat. Raising the first mine was always the most perilous undertaking, because no one knew just what type of mine it was and how to handle it with safety, or whether there was any way in which it _could_ be made harmless. There were some mines, for instance, that contained within them a small vial partly filled with sulphuric acid. The mine carried no prongs, but if it were tilted more than twenty degrees the acid would spill out and blow up the mine. Such a mine would be exceedingly difficult if not impossible to handle from a boat that was rocked about by the waves.