The workman has an iron rod with a sort of crank-like handle at the end of it, and this rod he inserts into the bore of the barrel which he has in hand. The rod fits into the barrel closely, and is held firmly by the friction, so that by means of the handle to the rod, the workman can turn the barrel round and round continually while he is grinding it, and thus bring the action of the stone to bear equally upon every part, and so finish the work in a true cylindrical form. One of these rods, with its handle, may be seen lying free upon the stand on the right of the picture. The workman is also provided with gauges which he applies frequently to the barrel at different points along its length, as the work goes on, in order to form it to the true size and to the proper taper. In the act of grinding he inserts the barrel into a small hole in the case, in front of the stone, and then presses it hard against the surface of the stone by means of the iron lever behind him. By leaning against this lever with greater or less exertion he can regulate the pressure of the barrel against the stone at pleasure. In order to increase his power over this lever he stands upon a plate of iron which is placed upon the floor beneath him, with projections cast upon it to hold his feet by their friction; the moment that he ceases to lean against the lever, the inner end of it is drawn back by the action of the weight seen hanging down by the side of it, and the barrel is immediately released.
The workman _turns_ the barrel continually, during the process of grinding, by means of the handle, as seen in the drawing, and as the stone itself is revolving all the time with prodigious velocity, the work is very rapidly, and at the same time very smoothly and correctly performed.
It would seem too, at first thought, that this operation of grinding must be a very safe as well as a simple one; but it is far otherwise. This grinding room is the dangerous room--the only dangerous room, in fact, in the whole establishment. In the first place, the work itself is often very injurious to the health. The premises are always drenched with water, and this makes the atmosphere damp and unwholesome. Then there is a fine powder, which, notwithstanding every precaution, will escape from the stone, and contaminate the air, producing very serious tendencies to disease in the lungs of persons who breathe it for any long period. In former times it was customary to grind bayonets as well as barrels; and this required that the face of the stone should be fluted, that is cut into grooves of a form suitable to receive the bayonet. This fluting of the stone, which of course it was necessary continually to renew, was found to be an exceedingly unhealthy operation, and in the process of grinding, moreover, in the case of bayonets, the workman was much more exposed than in grinding barrels, as it was necessary that a portion of the stone should be open before him and that he should apply the piece in hand directly to the surface of it. From these causes it resulted, under the old system, that bayonets, whatever might have been their destination in respect to actual service against an enemy on the field, were pretty sure to be the death of all who were concerned in making them.