The term separator in oilfield terminology designates a pressure vessel used for separating well fluids produced from oil and gas wells into gaseous and liquid components. A separator for petroleum production is a large vessel designed to separate production fluids into their constituent components of oil, gas and water. A separating vessel may be referred to in the following ways: Oil and gas separator, Separator, Stage separator, Trap, Knockout vessel (Knockout drum, knockout trap, water knockout, or liquid knockout), Flash chamber (flash vessel or flash trap), Expansion separator or expansion vessel, Scrubber (gas scrubber), Filter (gas filter). These separating vessels are normally used on a producing lease or platform near the wellhead, manifold, or tank battery to separate fluids produced from oil and gas wells into oil and gas or liquid and gas. An oil and gas separator generally includes the following essential components and features:

A vessel that includes (a) primary separation device and/or section, (b) secondary "gravity" settling (separating) section, (c) mist extractor to remove small liquid particles from the gas, (d) gas outlet, (e) liquid settling (separating) section to remove gas or vapor from oil (on a three-phase unit, this section also separates water from oil), (f) oil outlet, and (g) water outlet (three-phase unit). Adequate volumetric liquid capacity to handle liquid surges (slugs) from the wells and/or flowlines. Adequate vessel diameter and height or length to allow most of the liquid to separate from the gas so that the mist extractor will not be flooded. A means of controlling an oil level in the separator, which usually includes a liquid-level controller and a diaphragm motor valve on the oil outlet. A back pressure valve on the gas outlet to maintain a steady pressure in the vessel. Pressure relief devices.

Separator (oil production)

Separators work on the principle that the three components have different densities, which allows them to stratify when moving slowly with gas on top, water on the bottom and oil in the middle. Any solids such as sand will also settle in the bottom of the separator. The functions of oil and gas separators can be divided into the primary and secondary functions which will be discussed later on.

Separator (oil production)

Classification of oil and gas separators

By operating configuration

Oil and gas separators can have three general configurations: vertical, horizontal, and spherical. Vertical separators can vary in size from 10 or 12 inches in diameter and 4 to 5 feet seam to seam (S to S) up to 10 or 12 feet in diameter and 15 to 25 feet S to S. Horizontal separators may vary in size from 10 or 12 inches in diameter and 4 to 5 feet S to S up to 15 to 16 feet in diameter and 60 to 70 feet S to S. Spherical separators are usually available in 24 or 30 inch up to 66 to 72 inch in diameter. Horizontal oil and gas separators are manufactured with monotube and dual-tube shells. Monotube units have one cylindrical shell, and dual-tube units have two cylindrical parallel shells with one above the other. Both types of units can be used for two-phase and three-phase service. A monotube horizontal oil and gas separator is usually preferred over a dual-tube unit. The monotube unit has greater area for gas flow as well as a greater oil/gas interface area than is usually available in a dual-tube separator of comparable price. The monotube separator will usually afford a longer retention time because the larger single-tube vessel retains a larger volume of oil than the dual-tube separator. It is also easier to clean than the dual-tube unit. In cold climates, freezing will likely cause less trouble in the monotube unit because the liquid is usually in close contact with the warm stream of gas flowing through the separator. The monotube design normally has a lower silhouette than the dual-tube unit, and it is easier to stack them for multiple-stage separation on offshore platforms where space is limited. It was illustrated by Powers et al (1990) that vertical separators should be constructed such that the flow stream enters near the top and passes through a gas/liquid separating chamber even though they are not competitive alternatives unlike the horizontal separators.

Separator (oil production)