In manufacturing soap powders, the dried soap chips might be mixed with the filler and alkali and then pulverized. This method is not extensively employed nevertheless. The process which is the most economical is one whereby the ingredients are mixed in a specially adapted mixer for heavy material until dry and then run directly to the crusher and pulverizer, after which it is automatically packed, sealed and boxed. Another method of procedure is to run out the mixture from the crutcher to the frames, which are stripped before the soap cools, and is cut up at once, for if it hardens it could not be cut with wires. It is better, however, to run the mixture into sheets upon a specially constructed floor and break up the mass when cool.

Formulae for soap powders which have been found to be suitable for running dry in the mixer follow:

Soap-Making Manual — Part 39

I Soda ash, 58 per cent. 42 lbs. Silica 220 " Settled soap (usually cottonseed). 25 " Salt 10 "

Soap-Making Manual — Part 39

II Soap (settled cottonseed) 40 lbs. Soda ash, 58 per cent. 60 "

Soap-Making Manual — Part 39

III Settled soap 100 lbs. Soda ash, 58 per cent. 400 "

Fillers in varying proportions may replace the soda ash in the above formulae. It is of course understood that the soap has been previously made and run as molten soap into the crutcher.

The following soap powders will not dry up in the crutcher upon running, but are of the class which may be framed or run on the floor to solidify:

I Soap 850 lbs. Filler 400 " Sal soda solution, 20 degs. B 170 "

II Soap 650 lbs. Filler 550 " Sal soda solution, 20 degs. B. 340 "

III Soap 80 lbs. Filler 550 " Sal soda solution 170 "

IV Soap (settled tallow) 800 lbs. Filler 400 " Sal soda solution 170 " Water 100 "

First saponify 100 parts house grease and 100 parts ordinary grease and make a run soap. Then use in crutcher either:

Soap 400 lbs. Filler 575 " Hot water 60 " or Soap 200 lbs. Hot water 200 " Filler 625 "

It would be a simple matter to write numerous additional formulae, but the above are typical. The manufacturer must judge for himself just what filling material to use. The filler indicated in the above formulae is therefore left open. A few formulae for more expensive powders than those given recently appeared among others in the "Seifensieder Zeitung"[9]: