Other small animals, such as rats, mice, ground squirrels, gophers, etc., can be dressed in the same manner. After stuffing smooth the hair and shape the body before laying away.

ARTICLE VIII. MODE OF DRESSING AND PRESERVING TURTLES.

Barbers' Manual (Part 1), Text Book on Taxidermy (Part 2) — Part 23

A good sized turtle may be thoroughly preserved without the tedious process of unjointing, skinning, digging out the flesh, sewing up, etc., by observing the following directions:

Barbers' Manual (Part 1), Text Book on Taxidermy (Part 2) — Part 23

Take a snapping, or any other hard shell turtle, say one that measures ten inches across the back, or smaller, down to the smallest.

Barbers' Manual (Part 1), Text Book on Taxidermy (Part 2) — Part 23

The first thing to be done is to kill it, which is the hardest part of the operation, as it clings to life tenaciously, and large ones are very strong and hard to manage. One way is to get it to open its mouth, and catch it by the under jaw with a pair of strong pliers, hold its mouth open and make it swallow a quantity of the solution of corrosive sublimate; this being a deadly poison, it will soon kill it.

Another way is to hold its head as far out as you can pull it, and stick it as close to the under shell as you can, running the blade well back into the body. It takes some time for it to die after being stuck.

And still another way is to open its mouth and stick a knife blade up through the roof of the mouth into the brain.

I prefer the poisoning, as it seems to die easier and quicker, and it does not disfigure it. As soon as it dies, lay it on its back, and make an opening in the skin, under one of the back legs, large enough to take out all the entrails; now take a pair of pliers or a hook (made for the purpose); pull out all the entrails, liver, heart, etc. If the specimen is a large one, pour in some water and rinse out thoroughly, then put in a lot of the preserving powder, being careful to get it well distributed through the body. Then take some cotton and dust it well with the preserving powder, and fill up the inside, pressing the cotton in tight, filling the body full and sew up. Now open the mouth and pour some of the solution of corrosive sublimate down its throat, and press some cotton sprinkled with the powder down its throat, being careful not to stretch the neck out of proportion. Remove the eyes and insert the artificial eyes in their stead; fill the mouth with cotton and close it. Cut a hole in the bottom of each foot, and probe the legs with a knife or the blunt end of a wire; pour in some of the solution of corrosive sublimate, or work in enough of the powder to preserve the flesh; if the tail is a large one, it should be treated in the same way, and all sewed up. Now set it on a board and tack the feet to the board in as near the way it would hold them while walking as you can. Pull the neck out a very little, and put a little block or a small roll of cotton under it to hold it up in position while drying. Before putting it on the drying board, take a small paint brush, pour out some of the solution of corrosive sublimate in a dish and give the whole outer surface a thorough wetting. This should be repeated once a day for several days. This completes the dressing. After the specimen is dry, take it off the board and set in the cabinet.