_Congenital Dislocation at the Hip._--Possibly as a result of faulty position of the subject during intra-uterine life, the head of the thigh-bone leaves, or fails throughout to occupy, its normal situation on the haunch-bone. The defect, which is a very serious one, is probably not discovered until the child begins to walk, when its peculiar rolling gait attracts attention. The want of fixation at the joint permits of the surgeon thrusting up the thigh-bone, or drawing it down in a painless, characteristic manner.
The first thing to be done is to find out by means of the X-rays whether a socket exists into which, under an anaesthetic, the surgeon may fortunately be enabled to lodge the end of the thigh-bone. If this offers no prospect of success, there are three courses open: First, to try under an anaesthetic to manipulate the limb until the head of the thigh-bone rests as nearly as possible in its normal position, and then to endeavour to fix it there by splints, weights and bandaging until a new joint is formed; second, to cut down upon the site of the joint, to scoop out a new socket in the haunch-bone, and thrust the end of the thigh-bone into it, keeping it fixed there as just described; and third, to allow the child to run about as it pleases, merely raising the sole of the foot of the short leg by a thick boot, so as to keep the lower part of the trunk fairly level, lest secondary curvature of the spine ensue. The first and second methods demand many months of careful treatment in bed. The ultimate result of the second is so often disappointing that the surgeon now rarely advises its adoption. But, if under an anaesthetic, as the result of skilful manipulation the head of the thigh-bone can be made to enter a more or less rudimentary socket, the case is worth all the time, care and attention bestowed upon it. Sometimes the results of prolonged treatment are so good that the child eventually is able to walk with scarce a limp. But a vigorous attempt at placing the head of the bone in its proper position should be made in every case. (E. O.*)
JOINTS, in engineering, may be classed either (a) according to their material, as in stone or brick, wood or metal; or (b) according to their object, to prevent leakage of air, steam or water, or to transmit force, which may be thrust, pull or shear; or (c) according as they are stationary or moving ("working" in technical language). Many joints, like those of ship-plates and boiler-plates, have simultaneously to fulfil both objects mentioned under (b).