(_N_/|30|)/8 in eighths of inches, or _N_/240 inches.

The upper fifteen to eighteen inches of the barrel must be left for steam room.

Handbook of Railroad Construction — Part 185

357. To find the diameter of a barrel to contain a given number of tubes,

Handbook of Railroad Construction — Part 185

Represent the inside diameter of boiler by _D_, Diameter of one tube _d_, Clearance between tubes _c_, Number of tubes _n_, Sectional area of boiler, in inches _A_, Water section, in inches _B_,

Handbook of Railroad Construction — Part 185

we shall have as the area of water room per tube,

_D_ = √(([(_d_ + _c_)^2_n_]_A_/_B_)/.7854)

which is the boiler diameter in inches, to which add _D_/16 on each side, or in all _D_/8 as the room to be left between the sides of the boiler and first tube.

The _diameter_ finds its maximum limit in the gauge less the two half breadths of tire, and two or three inches allowance for attachment to the frame and other mechanical incidentals. The _length_ must be enough to carry the leading wheels a sufficient distance from the centre of gravity of the engine.

ADAPTATION OF THE LOCOMOTIVE ENGINE TO THE MOVEMENT OF RAILWAY TRAINS.

358. First, as regards the nature of the traffic.

There are certain necessary causes of a bad application of power upon railroads; for example, when the trains are very much heavier in one direction than in the other, as we are obliged to use the same engine both ways, because when it arrives at one end of the road it must go back to start again. Where the traffic requires to be worked chiefly up hill, we use an engine much heavier to _ascend with the load_ than is necessary to _descend without a load_. Different objects of transport require different speeds. Perishable freight, such as ice, beef, pork, cattle, &c., requires to be moved in much less time than grain, lumber, flour, coal, and manufactured articles. As a general thing, the difference between the characters of freight engines, as regards the nature of the traffic, can be adapted only with a view to amount, disregarding the nature.

With passenger traffic, however, there is a great variety of speeds made use of, and consequently may be a greater difference in the proportions of engines depending entirely upon the nature of the traffic.

ADAPTATION AS REGARDS THE PHYSICAL CHARACTER OF THE ROAD.

The best adaptation of locomotive power to any system of grades, would be that which should render the mileage a minimum; and this will be done, as nearly as possible, by applying engines, the strength of which shall be proportional to the resistance to be overcome. The best mode of comparing different adaptations of power is by reducing the grades to a level; or by equating for grades by means of the capacity of motive power.