=Cotton Finishing.= Cotton fabrics, like other textiles, after leaving the loom must be subjected to various finishing processes so as to bring them into commercial condition. On piece-dyed goods part of the finishing is done before and part after the dyeing process. Each class of fabrics has definite finishing processes. In some cases weighting materials are added to the fabric so as to hide more or less its actual construction. Cotton fabrics just from the loom present a soft and open structure, more so than other textiles. Therefore it is necessary to use proper finishing materials and processes which will fill up the openings or interstices as produced in the fabric by the interlacing of warp and filling, and at the same time give to the fabric a certain amount of stiffness. Of course this finish will disappear during wear or washing, it having been imparted to the fabric to bring the latter into a salable condition.
Cotton fabrics after weaving may be subjected to the following sub-processes of finishing:
Inspecting, Burling and Trimming, Bleaching, Washing, Scutching, Drying.
After the cloth leaves the loom it is brushed; then it passes over to the inspection table in an upward receding direction, so that the eye of the operator can readily detect imperfections. The ends of two or more pieces as coming from the loom are sewed into a string for convenient handling in the bleaching.
=Bleaching.= The object of bleaching is to free the cotton from its natural color. The ancient method of bleaching by exposure to the action of the sun's rays and frequent wetting has been superseded by a more complicated process involving the use of various chemicals. Pieces of cloth are tacked together (sewed) to form one continuous piece of from three to one thousand yards in length. The cloth is next passed over hot cylinders or a row of small gas jets to remove all the fine, loose down from the surface. The goods are then washed and allowed to remain in a wet condition for a few hours, after which they are passed through milk of lime under heavy pressure, followed by rinsing in clear water. The goods are next "scoured" in water acidulated with hydrochloric acid, and boiled in a solution of soda, then washed as before in clear water. Next they are chlorined by being laid in a stone cistern containing a solution of chloride of lime and allowed to remain a few hours. This operation requires great care in the preparation of the chloride of lime, for if the smallest particle of undissolved bleaching powder is allowed to come in contact with and remain upon the cloth it is liable to produce holes. The goods are then boiled for four or five hours in a solution of carbonate of soda, after which they are washed. They are again chlorined as before and washed. The long strips are finally scoured in hydrochloric acid, washed, and well squeezed between metal rollers covered with cloth. After squeezing and drying, the cloth, if required for printing, needs no further operation, but if intended to be marketed in a white state, it must be finished, that is, starched or calendered.