[Illustration: JONATHAN HULLS’S STEAM-BOAT.]
[48] In describing his mode of obtaining rotary motion by ratchet wheels, a weight, and ropes, Hulls states that he uses two axes, one behind the other, each of which is essential to the object; and he then adds, that when his tow-boat is to be used in shallow rivers, the machine works by two cranks fixed to the hindermost axis; to which cranks are fixed two shafts (or poles) of proper length to reach the bottom of the river, and which move alternately forward _from the motion of the wheels by which the vessel is carried on_: so that the cranks, as described by Hulls, receive rotary motion from the axis on which they are placed, and do not, as has been erroneously stated, impart that motion to it.--Bennet Woodcroft, ‘Sketch of the Origin and Progress of Steam Navigation.’ London, 1848.
The inventor, aware of the novelty of his proposal and of the readiness of the public to ridicule novelties, deprecated rash censure of his project, and only claimed for it a fair and unprejudiced trial. In order to exhibit the powers of his steam-boat, he constructed an engine in 1737, and had it fixed on board a little vessel for trial in the river Avon at Evesham. The trial was not satisfactory, and the engine was taken on shore again. “A failure! A failure!” cried the spectators, who stigmatised the projector as an ass. The prophet had, indeed, no honour whatever in his own country. Long after his steam-boat experiment had been forgotten, these lines about him were remembered:--
“Jonathan Hull, With his paper skull, Tried hard to make a machine That should go against wind and tide: But he, like an ass, Couldn’t bring it to pass, So at last was ashamed to be seen.”[49]
Not much more is known of Jonathan Hulls’s history. In 1754 he published, in conjunction with two others, a treatise on ‘The Art of Measuring made Easy, by the help of a new Sliding-rule;’ and shortly after ‘The Malt-maker’s Instructor;’ but nothing more was heard of Jonathan Hulls’s steam-boat.
[49] There are several versions of the same satire current to this day in the villages of Campden and Hanging Aston.
We return to the Newcomen engine, which became increasingly employed as a pumping power in all the mining districts. Borlase, writing in 1758, says that “fire-engines” were then in regular use at North Downs near Redruth, Pitt-louarn, Polgooth, Wheal-rith, Pool, Dolcoath, Herland, and many other places.[50] Indeed there was scarcely a tin or copper mine of any importance in Cornwall that had not one or more of Newcomen’s engines at work. They were also in general use in Staffordshire, Yorkshire, Lancashire, and Northumberland. In the latter counties, where they were principally used for pumping water out of the coal mines, fuel was ready at hand, cheap and abundant. But in Cornwall it was otherwise. The coal had to be brought thither from a great distance, partly by sea and partly by land, and the cost of carriage was very heavy. It, therefore, became an object of much importance to reduce the consumption of fuel, to prevent the profits of the mines being absorbed by the heavy cost of working the pumps. This, indeed, was the great objection to Newcomen’s engine, especially in Cornwall. The consumption of fuel at some mines was so enormous, that it was doubtful whether the cost of steam did not exceed that of an equal amount of horse power, and it became more and more difficult to realise even a bare margin of profit. The two engines at Wheal Rose and Wheal Busy, near Chacewater, of 66 and 72 inches diameter, consumed each about thirteen tons of coal daily. To relieve the mining interest, in some measure, from this charge, government allowed a drawback of five shillings a chaldron on coal; but in some cases this was found insufficient, and it began to be complained that the consumption of coal was so great, that the mines were barely paying.