These glass jars are placed in trays of sand and the trays rest on glass insulators. The normal charge and discharge rate of this battery is 5 amperes, although in starting the motor generator a much higher current is drawn from the battery. The voltage is about 80.

Q. What precautions are necessary to keep it in order?

The Gunner's Examiner — Part 87

A. 1^o Do not overcharge, overdischarge, or allow to stand completely discharged. (Battery should be charged when discharge is 1.8 volts per cell.)

The Gunner's Examiner — Part 87

2^o Keep plates covered with electrolyte about ¾ inch above top of plates. If not at proper height add distilled water.

The Gunner's Examiner — Part 87

4^o A record of each cell (voltage and specific gravity) should be kept each time the battery is charged, and this should be done about once a week.

5^o The indications of a complete charge are: when positive plates have a deep chocolate color, negative light slate, cells gas freely, each cell reads about 2·5 volts, and 1.210 specific gravity, and when no perceptible rise in voltage occurs for a lapse of 10 to 15 minutes.

6^o If any low cells develop, bring them back into condition immediately.

(_a_) If voltage is very low, look for sediment or foreign matter, then charge separately.

[Illustration: STORAGE CELL (DISMANTLED) FIG. 103.]

(_b_) If specific gravity is very low take out some electrolyte and add 1.200 specific gravity electrolyte. (This used to be 1.400.)

7^o Keep battery-room well ventilated, especially while charging.

8^o Never bring an exposed flame into battery-room while charging. (The gases given off are explosive when mixed with air.)

9^o Keep the floor and all parts of the room clean, iron, copper, and metal work free from corrosion; keep all connections tight and clean; never allow verdigris to collect _anywhere_.

A. It consists of an iron cylinder mounted on an iron pedestal in a yoke. The cylinder contains a parabolic mirror in the back, a series of glass strips in the front, and two "carbons" in the middle.

The electric current in passing through the carbons heats the points to a very high degree, producing a brilliant light. This light is reflected by the mirror towards the front, and the mirror, being of a curved form, also converges the rays of light. Underneath most searchlights are electric motors for traversing and elevating, and these motors are started or stopped by means of switches in a contrivance called a "controller," which is always placed at a distance from the light.