The nature of the cut itself in pruning is of more consequence, especially in the case of fruit trees, than at first sight may appear. The branches should be separated by a clean cut at an angle of about 45°, just at the back of a bud, the cut entering on a level with the base of the bud and passing out on a level with its top (fig. 36, a), for when cut in this way the wound becomes rapidly covered with new wood, as soon as growth recommences, whereas if the cut is too close the bud is starved, or if less close an ugly and awkward snag is left. Fig 36, b and c, are examples of the former, and d, e, f of the latter. In fact there is only one right way to cut a shoot and that is as shown at a.
The _Pruning of flowering plants_ is generally a much lighter matter than the pruning of fruit trees. If a young seedling or cutting of any soft-wooded plant is to be bushy, it must have its top nipped out by the thumb-nail or pruning-scissors at a very early stage, and this stopping must be repeated frequently. If what is called a well-furnished plant is required, an average of from 2 to 3 in. is all the extension that must be permitted--sometimes scarcely so much--before the top is nipped out; and this must be continued until the desired size is attained, whether that be large or small. Then generally the plant is allowed to grow away till bloom or blooming shoots are developed. To form a pyramidal plant, which is a very elegant and useful shape to give to a decorative pot plant, the main stem should be encouraged to grow upright, for a length perhaps of 6 or 8 in. before it is topped; this induces the formation of laterals, and favours their development. The best-placed upper young shoot is selected and trained upright to a slender stake, and this also is topped when it has advanced 6 or 8 in. further, in order to induce the laterals on the second portion to push freely. This process is continued till the required size is gained. With all the difficult and slow-growing plants of the hard-wooded section, all the pruning must be done in this gradual way in the young wood as the plant progresses.
[Illustration: FIG. 36.--Cuts--Good and Bad.]
Some plants, like pelargoniums, can only be kept handsomely formed and well furnished by cutting them down severely every season, after the blooming is over. The plants should be prepared for this by keeping them rather dry at the root, and after cutting they must stand with little or no water till the stems heal over, and produce young shoots, or "break," as it is technically termed. The appearance of a specimen pelargonium properly pruned is shown in fig. 37, in which a shows a young plant, the head of which has been taken off to form a cutting, and whose buds are ready to break into young shoots. Three shoots will be produced, and these, after growing from 4 to 6 in. in length, should be stopped by pinching out the point, this giving rise to lateral shoots. These will blossom in due course, and, after being ripened thoroughly by full exposure to the sun, should be cut back as shown at b. This is the proper foundation for a good specimen, and illustrates how all such subjects should be pruned to keep them stocky and presentable in form.