TOPS-20-The Daily Ledger

The TOPS-20 operating system by Digital Equipment Corporation (DEC) is a proprietary OS used on some of DEC's 36-bit mainframe computers. The Hardware Reference Manual was described as for "DECsystem-10/DECSYSTEM-20 Processor" (meaning the DEC PDP-10 and the DECSYSTEM-20).

TOPS-20 began in 1969 as the TENEX operating system of Bolt, Beranek and Newman (BBN) and shipped as a product by DEC starting in 1976. TOPS-20 is almost entirely unrelated to the similarly named TOPS-10, but it was shipped with the PA1050 TOPS-10 Monitor Calls emulation facility which allowed most, but not all, TOPS-10 executables to run unchanged. As a matter of policy, DEC did not update PA1050 to support later TOPS-10 additions except where required by DEC software.

TOPS-20

TOPS-20 competed with TOPS-10, ITS and WAITS—all of which were notable time-sharing systems for the PDP-10 during this timeframe.

TOPS-20

TENEX

TOPS-20 was based upon the TENEX operating system, which had been created by Bolt Beranek and Newman for Digital's PDP-10 computer. After Digital started development of the KI-10 version of the PDP-10, an issue arose: by this point TENEX was the most popular customer-written PDP-10 operating systems, but it would not run on the new, faster KI-10s. To correct this problem, the DEC PDP-10 sales manager purchased the rights to TENEX from BBN and set up a project to port it to the new machine. In the end, very little of the original TENEX code remained, and Digital ultimately named the resulting operating system TOPS-20.

TOPS-20

PA1050

Some of what came with TOPS-20 was merely an emulation of the TOPS-10 Operating System's calls. These were known as UUO's, standing for Unimplemented User Operation, and were needed both for compilers, which were not 20-specific, to run, as well as user-programs written in these languages. The package that was mapped into a user's address space was named PA1050: PA as in PAT as in compatibility; 10 as in DEC or PDP 10; 50 as in a PDP 10 Model 50, 10/50, 1050.

Sometimes PA1050 was referred to as PAT, a name that was a good fit to the fact that PA1050, "was simply unprivileged user-mode code" that "performed the requested action, using JSYS calls where necessary."

TOPS-20 capabilities

The major ways to get at TOPS-20 capabilities, and what made TOPS-20 important, were Commands entered via the command processor, EXEC.EXE JSYS (Jump to System) calls from MACro-language (.MAC) programs

The "EXEC" accomplished its work primarily using

internal code, including calls via JSYS

requesting services from "GALAXY" components (e.g. spoolers)

Command processor

Rather advanced for its day were some TOPS-20-specific features: Command completion Dynamic help in the form of noise-words - typing DIR and then pressing the ESCape key resulted in DIRectory (of files) typing and pressing the key resulted in Information (about)

One could then type to find out what operands were permitted/required. Pressing displays status information.