Notwithstanding all this, I cannot recommend making a _good_ stock better by adding the bees from another good one as a source of profit. I tried it a few times. I had purchased some large hives for market, and wished to dispose of the bees without sulphur, and try the experiment of uniting two or more. The next spring when they commenced work such double stocks promised much; but when the swarming season arrived, the single swarms, such as were good and had just about bees enough, were in the best condition, in ordinary seasons. Whether this was owing to the circumstance of there being already bees enough that were beginning to crowd and interfere with each other's labors, and less brood raised in consequence, or to some other reason, I cannot say. I have often noticed, (as others have), that stocks which have cast no swarms, are no better the next spring than others. The same cause might operate in both cases. Therefore it would appear unnecessary to unite two or more _good swarms_, unless it is to spare our feelings in destroying the bees. The two extremes may generally be avoided, and not have too many or too few bees.

The season for operating is, generally, when all the brood has matured and left the cells. The exceptions are when there are not bees enough to protect the stores; it may then be necessary, immediately after the failure of honey.

Mysteries of Bee-keeping Explained — Part 169

Col. H. K. Oliver, of Salem, Mass., is said to be the inventor of the fumigator, an instrument to burn fungus (_puff-ball_). By the aid of this the smoke is blown in the hive, paralyzing the bees in a few minutes; when they fall to the bottom, apparently dead, but will recover in a few minutes, on receiving fresh air.

Mysteries of Bee-keeping Explained — Part 169

I am indebted to a communication from J. M. Weeks, published on page 151 of the Cultivator for 1841, for this method. The description of the fumigator that I constructed will vary a trifle from his, but will retain the principle. I obtained a tin tube four inches long, and two in diameter. Next, I made a stopper of soft wood, three inches long, to exactly fit one end of the tube when driven in half an inch, and secured it by little nails driven through the tin. Through the centre of this stopper I made a hole one-fourth of an inch in diameter. To prevent this hole filling up, the end in the tube was covered over with wire cloth, made a little convex. The end of this stopper was cut down to about half an inch, tapering it from the tin. For the other end a similar piece of wood is fitted, though a little longer, and not to be fastened, as it must be taken out for every operation. The outer end of this is cut down into a shape to be taken into the mouth, or attached to the pipe of a bellows. (I fitted them in the turning lathe, but have seen them fixed very nicely without.) It could all be made of tin; but then it is necessary to use solder, which is liable to melt and cause leaks.

Mysteries of Bee-keeping Explained — Part 169