A SELVAGEE.--Lay rope yarns round and round in a bight, and marl them down with spunyarn. These are used for neat block-straps, and as straps to go round a spar for a tackle to hook into, for hoisting.
A MARLINSPIKE HITCH--Lay the marlinspike upon the seizing-stuff, and bring the end over the standing part so as to form a bight. Lay this bight back over the standing part, putting the marlinspike down through the bight, under the standing part, and up through the bight again.
TO PASS A ROUND SEIZING.--Splice a small eye in the end of the stuff, take the other end round both parts of the rope, and reeve it through the eye. Pass a couple of turns, then take a marlinspike-hitch, and heave them taut. Pass six, eight or ten turns in the same manner, and heave them taut. Put the end through under these turns and bring it out between the two last turns, or through the eye, and pass five, seven or nine turns (one less than the lower ones) directly over these, as riders. The riders are not hove so taut. Pass the end up through the seizings, and take two cross turns round the whole seizing between the two, passing the end through the last turn, and heaving taut. If the seizing is small cordage, take a wall-knot in the end; if spunyarn, an overhand knot. The cross turns are given up now in nearly all vessels. After the riding turns are passed, the end is carried under the turns, brought out at the other end, and made fast snugly to the standing part of the rigging.
A THROAT SEIZING, where rigging is turned in, is passed and made fast like the preceding, there being no cross turns. A neat way to pass a throat seizing is to pass the turns rather slack, put a strap upon the end of the rigging, take a handspike or heaver to it and bear it down, driving home the seizing with a mallet and small fid.
STOPPING, is fastening two parts of a rope together as for a round seizing, without a crossing.
NIPPERING, is fastening them by taking turns crosswise between the parts, to jam them; and sometimes with a round turn before each cross. These are called _racking turns_. Pass _riders_ over these and fasten the end.
POINTING.--Unlay the end of a rope and stop it. Take out as many yarns as are necessary, and split each yarn in two, and take two parts of different yarns and twist them up taut into _nettles_. The rest of the yarns are combed down with a knife. Lay half the nettles down upon the scraped part, the rest back upon the rope, and pass three turns of twine taut round the part where the nettles separate, and hitch the twine, which is called the _warp_. Lay the nettles backwards and forwards as before, passing the warp, each time. The ends may be whipped and snaked with twine, or the nettles hitched over the warp and hauled taut. The upper seizing must be snaked. If the upper part is too weak for pointing, put in a piece of stick.