40. Belaying-pin opened to serve as a button; these are used where it is necessary to stop or check velocity.

42. Variable or regulating lashing. By laying the piece, a f, horizontally, it can be slipped along the rope, b; by raising or lowering this, we shall raise or depress the weight, c, the cord, b, running over the two pulleys, d, from the piece, a f, in the direction shown in the figure. The friction of the cord, b, passing through the hole, e, sufficiently fixes the piece, a f, and holds the weight, c, securely.

Scientific American, Volume XXIV., No. 12, March 18, 1871 — Part 9

44. Cleet, showing the mode of belaying the cord.

Scientific American, Volume XXIV., No. 12, March 18, 1871 — Part 9

49. A "bend" which is only used for fear of the stoppers snapping.

Scientific American, Volume XXIV., No. 12, March 18, 1871 — Part 9

50. Bastard loop, made on the end of the rope, and whipped with yarns.

51. Tie to pins: a, the pin; b, small cords fixed by a cross tie.

52. Cleet, fixed to the "rail," either with screws or nails, to which the lines are belayed.

57. Fastening by a loop. This can be tied or untied without loosening the loop itself. It is made by following, towards the longer loop, the direction as numbered 1, 2, 3, 4, 5, and is terminated by the loop, 6, 7, 6, finally passing it over the head of the post, A. This knot holds itself, the turns being in opposite directions. To untie it, we slack the turns of the cable sufficiently to again pass the loop, 6, 7, 6, over the post, A, and turn the ends in the contrary direction to that in which they were made (as 5, 4, 3, 2, 1).

59 and 60. "Wedding" knots; a b, eyelets; c d, the join; e, the fastening.

61. Lark's-head fastening to running knot.

62. A round turn; the cord, a, is passed through the bight of the cord, b, over the button, c, where it is secured by an ordinary knot.

63. Belaying-pin splice. The cord, b, "stops" the pin, e, its end being spliced upon itself, and "served" with yarn; this rope, with its pin, is passed through the spliced eye, f of the line, g.

65. Joint by a spherical shell, each loop, a and b, being made by ties and splices, and surrounding the shell, c.

66. Belaying-pin, shown separately, before being stoppered.

68. Square mooring. When the cable is round the post, A, and the piece, c, without being crossed, it lays in the section 1, 2, 3, 4, 5, 6, 7, and the end is fastened by tying.

70. Crossed fastening. The turns of the cable, passing in front of the post, B, are crossed at the back of C, in the direction 1, 2, 3, 4, 5, 6, 7, 8, the end, 8, being secured to the cable.