They found the doctor at a bench that he had rigged up in his barn. On the wall was arranged a large variety of tools and on the bench were strewn several coils of wire and a number of objects the name and use of which the boys did not know.

The doctor, who was in his shirt sleeves, extended a hearty welcome to the boys, who ranged themselves about him, and whose numbers were constantly augmented by newcomers until the barn was well filled.

The Radio Boys' First Wireless — Part 26

"What I want to do to-day, boys," he said, "is to show you how easy and simple it is to put up a wireless telephone receiving set without having to spend very much money.

The Radio Boys' First Wireless — Part 26

"Now the first thing you have to get and put up is the aerial," he remarked, as he unwound a large coil of copper wire. "You want about a hundred or a hundred and twenty feet of that. You can extend it horizontally for about fifty feet, say, for instance, from the side or back of your house to the barn or the garage, and then have it go up as high as it can go. The upper end doesn't have to be in the outer air, for the sound will come along it if it's in the attic. Still it's better to have it outside if possible. The lower end of the wire has to be connected with the ground in some way, and you can fix that by attaching it to a water pipe or any other pipe that runs into the ground. A good way is to let it down the side of the house and put it through the cellar window and fasten it to a pipe.

The Radio Boys' First Wireless — Part 26

"After you have your aerial you want to get the rest of the apparatus together. The first thing to do is to get a baseboard which will serve as the bottom of the receiving box. Something like this," and he put his hand on a board about eighteen inches long, twelve inches wide, and about an inch thick. "This is the platform, as it were, on which the different parts of the apparatus are to rest.

"Now since your ear alone can't detect the waves that are coming to and along your aerial, you have to have a sort of electrical ear that will do this for you. Here it is," and he picked up a piece of crystal and a wire of phosphor bronze. "When this wire comes in contact with this bit of crystal the mysterious waves become audible vibrations.

"But this isn't enough. You've got to get in tune with the sending station in order to understand the sounds you hear. When your vibration frequency is the same as that from which the message is sent, you can hear as clearly as though the voice or instrument were in the next room. Now here's a piece of a curtain pole that's about a foot and a half long. You see that I've wound around its entire length, except for about a half inch at either end, a coil of wire. This is called the inductance coil. You will notice that the wire is covered with cotton except for this little strip of wire extending lengthwise where I've scraped the cotton off with sandpaper so as to accommodate the sliding contacts. These sliding contacts can be made from curtain rings with holes punched in them, through which are passed copper rivets. These rivets press against the bare path of the coil and can be moved to and fro until you find the exact point where your set is in tune with the sending station."