In order to get a shock from this coil it will be necessary to have a pair of handles and a current interrupter. The handles may be made from two pieces of tin rolled into the form of cylinders to which wires are soldered. Or, better yet, use pieces of thin brass tubing an inch in diameter. The buzzer shown in Fig. 9 may be employed for a current interrupter, and a bichromate battery will furnish the current.
In order to make the connections, the wires from the handles are attached to the binding-posts C and D in Fig. 8--that is, to the wires of the secondary coil. One spool of the battery is connected with A of Fig. 8 and the other with A of Fig. 9. A wire connects C of Fig. 9 with B of Fig. 8, and the circuit is closed. The buzzer now begins to vibrate, and any one holding the handles will receive a shock the intensity of which depends on the strength of the batteries. A switch should be introduced somewhere in the circuit, so that it may be opened or closed at will; a good place for it is between a battery-pole and the binding-post A in Fig. 8.
If the shock is too intense it may be weakened by drawing the carbon and zinc poles partly out of the bichromate solution; or a regulator may be made of a large glass tube and a glass preserving-jar filled with water. If the tube cannot be had, an Argand gas-burner chimney will answer as well.
Solder a wire to the edge of a small tin or copper disk, as shown in Fig. 10, on which the chimney rests at the bottom of the jar, and another wire to a tin box-cover with some small holes punched in its top, this latter being suspended within the chimney. This second wire is passed out through a cork at the top of the chimney made of a disk of cardboard and a piece of wood. One wire is connected with A of Fig. 8 and the other with a battery-pole. This apparatus acts the same as a resistance-coil, and by raising or lowering the box-cover the current is increased or diminished. The closer the cover comes to the disk the stronger the current, as there is less water for the electricity to pass through and therefore less resistance; while if the cover touches the disk the current flows as freely as if there were no regulator and the wires ran directly to the cell.