[Sidenote: _Double warp for Turkish rugs, etc., with fringe_]

Kiz-Kilim rugs have perforated or open-work patterns. To produce this effect string a _double_ warp through every notch in the foot and head pieces; that is, use two strings in each notch, tying in pairs for fringe as before. Use a brownish white carpet thread. With strong black thread string through every other notch to outline perpendicular sides of squares in the pattern. Your warp will be strung three-sixteenths inch, but the black threads will be three-eighths inch. This will enable you to keep the patterns straight as the work progresses.

Hand-Loom Weaving — Part 18

[Illustration: _A Kiz-Kilim rug pattern_]

Hand-Loom Weaving — Part 18

In drawing designs for Turkish rugs, where the pattern is to be placed under the warp, it is better to make a squared paper first. Lay the head piece of the loom upon unlined paper. Place a dot at every other notch. Draw perpendicular lines first, then dot for horizontal lines. The result will be a foundation to fit your loom. If the squared paper of the kindergarten be used the squares will be either too large or too small to correspond with the notches in the loom. It will be found very easy to transfer a pattern from a rug to the paper. Fasten the pattern under the warp by overhanding to the rods, taking care to have the black strings directly over the perpendicular lines in the pattern.

Hand-Loom Weaving — Part 18

[Sidenote: _Patterns for Navajo blankets_]

Patterns for Navajo blankets are usually triangular. Draw on unlined paper and fasten under the warp as before.

[Sidenote: _To string a continuous warp for long strips_]

Rugs and similar articles may be made of any length by stringing a continuous warp. After the length has been decided upon, cut the warp strings _twice_ as long. Place the middle of one string around the first tooth of the foot piece (or two or three, according to the width of warp desired) and bring up the two ends firmly to the first tooth in the head piece. Knot securely and let the long ends extend beyond the head piece. If desired they can be wound on spools, or around the tops of the rods, to prevent tangling. Continue until all the warp is strung. Observe the instructions given before for stringing warp strings in pairs. It is not necessary to weave the loom full each time, as the last inch is very slow work, but when the weaving is near the head piece draw out the rods, lift it from the notches, pass it down to the foot piece so that the part which was at the head is now at the foot, untie the knots so that the work will lie close to the foot piece and knot the warp strings as before at the head piece. This can be done as many times as desired.