There is a very handsome description of barrel-iron made, generally termed “Stub-Damascus.” The method of preparing it, is of late considerably altered. A quantity of old files are hardened, by being; heated red-hot and immersed in water, then broken in pieces with a hammer, and afterwards pounded in a mortar until the pieces do not exceed in size a corn of number five shot. A proportion of 15 lbs. of these to 25 lbs. of stubs, is fused together on the bed of an air-furnace, beaten down, and rolled into rods. The rod of 3-8ths of an inch square, is twisted like a rope, precisely in the same way as the Damascus. The effect of this winding, is to give a beautiful mottle to the barrel; which will be found depicted in plate No. 3.

Another mixture, represented in plate No. 2, was first made by Mr. Wiswould, of Birmingham. It is a compound, so far as I have been able to ascertain, of three parts of steel to two of iron, intimately blended and intermixed, and twisted as just described. It is a most beautifully clean and dense iron; but the extreme twisting is to it, as to all, highly injurious and prejudicial. The twisting is similar to the Damascus; only that two twisted rods are welded together instead of three, and with the twist of the strands running in opposite angles, as depicted in the wood-cut below.

Gunnery in 1858 — Part 104

The degree of strength is similar to that of the stub, and other Damascus; it being quite certain, that, be the composition what it may, this rending of the cohesive attachment by twisting, will eventually equalise the strength of the whole.

Gunnery in 1858 — Part 104

The use and introduction of what is called “charcoal-iron,” is one of the shams reared and supported by the hotbed of competition and deception combined: a wish to foist on the purchaser a counterfeit for the real metal. I would not give shop-room to the best barrels ever made from such a compound. I hate a scoundrel and a hypocrite; this iron exemplifies the qualities of both.

Gunnery in 1858 — Part 104

This worthless compound consists principally of cuttings of sheet iron; of which there is an endless supply in the neighbourhood of Birmingham, from punchings and from one inferior metal and another. After properly cleaning, a quantity is put into a charcoal furnace and melted, cast into a pig, then forged down to a bar, and rolled into rods corresponding with the size of stub twist, which it is intended to represent. The action of the charcoal communicates to it a portion of carbon, which, when stained in a certain way, gives an appearance much resembling that beautiful metal just mentioned (stub-Damascus); but if every means imagined by the inventive faculty of man were employed upon it, it could not be made into really good iron. An iron which is technically termed “weak,” can never be made a strong bodied iron, or an “iron suitable to make steel,” to repeat a former quotation. The original iron from which these scraps generally come, is required to be “weak” iron, for the facility with which it can be rolled into plates; a strong fibrous iron is not necessary.