82. Uses. We all know that compasses are used to point to the north and south, and we speak of the "points of the compass." This, of course, is the most important use of the compass, and it has been known for centuries. In the laboratory it is used to show or detect the presence of currents of electricity, and, in connection with coils of wire, it may show the relative strengths of two currents, etc. When used for such purposes it generally has special forms and sizes. (See Galvanometers and Detectors.)

_83. Compass._ An oily sewing-needle will float upon the surface of water, when it is carefully let down to the water. A little butter may be rubbed upon the previously-magnetized needle to make it float better.

How Two Boys Made Their Own Electrical Apparatus — Part 23

_84. Compass._ Fig. 38 shows a magnetized sewing-needle floated upon a cork. The needle may be permanently fastened to the cork with a few drops of melted paraffine.

How Two Boys Made Their Own Electrical Apparatus — Part 23

_85. Compass._ Fig. 39. With a sharp knife make a cut part way through a flat cork. Into the cut push a short length of magnetized watch-spring. In the illustration the spring is shown partly removed from the cut. Float the cork.

How Two Boys Made Their Own Electrical Apparatus — Part 23

_86. Compass._ Fig. 40. Stick a pin, P, into a pasteboard, cork, or wooden base, B. Bend a piece of stiff paper double, as shown, and then stick through it, on each side, a magnetized sewing-needle, S N. The north poles of the needles should be at the same end of the paper. Why? Balance the paper upon the pin-pivot, and see it fly around to the north and south.

_87. Compass._ Fig. 41. It is an advantage to have a magnetic needle that is always ready for use. The support is made by driving a pin through the top of a wooden pill-box, which should be about 1-3/4 in. in diameter. This gives plenty of room under and around the needle. If the pin be left too long, it will not be possible to put the bottom and top of the box together when you want to put the compass away. Cut the pin off (App. 35) at the right length, so that the magnetic needle can be safely put away in the closed pill-box.

88. The "Needle," that is the short bar magnet, may be made of watch-spring. As the spring is already quite hard and brittle, it may be easily broken into desired lengths. It is always better to make 3 or 4 needles at a time, as some will swing more easily than others, and time will be saved in making them. Break off 3 or 4 pieces of thin spring, each about 1-1/2 in. long. Bend them as in Fig. 42. A good dent, not a hole, should be made at the center of each to keep them upon the support or pin-point. A "center punch," not too sharp, is the best tool to use, but a slight dent may be made with a sharp wire nail, provided the watch-spring is first annealed or softened. (See App. 21.) Do not place the spring directly upon iron or steel when making the dent, as these might injure the point of the punch, and the dent would not be deep enough. Fig. 42 shows a good way to make dents in steel springs. Place 2 or 3 layers of copper or lead between the anvil and the spring. A hammer or hatchet will do for the anvil. As the copper will give easily, a good dent may be made by striking the punch or nail with a hammer. If the spring has been annealed before denting it, it should be hardened again (App. 21) before magnetizing it, so that it will retain magnetism well. (See Residual Magnetism in text-book.)