_63. Binding-Post._ Fig. 30. This makes a very simple and practical binding-post for home-made apparatus. It consists of a screw-eye, preferably of brass. The circle or eye should be about 3/8 or 1/2 in. in diameter. The thread on such a screw-eye will be about 1/2 in. long. Two copper burs are used to pinch the wires.
_64. Binding-Post._ Fig. 31. This consists of a screw, screw-eye, bur and a metal strip, 3/4 × 1-1/4 in. The apparatus wire should be fastened under the screw-head. Any outside wires which are to be joined to the apparatus should be clamped under the bur by turning the screw-eye. A small hole should be made in the wood before putting in the screw-eye. (See App. 25.) Do not turn the screw-eye too hard, or you will spoil the thread made in the wood.
_65. Binding-Post._ Fig. 32. The size of the bolt used in this form of binding-post will depend somewhat upon the thickness of the base of the apparatus. In general, a 3/4 or 7/8 in. base should be used where screws or screw-eyes are necessary. With this kind (Fig. 32) a thin base can be used. The head is shown counter-sunk into the bottom of the base. This is not necessary, provided at least 3 heads are placed far enough apart to form legs for the apparatus to stand on. Strips of wood may be nailed upon the underside of the base to make room for the heads in case they are not used as legs. The wires should be pinched between the nut and the copper bur shown. If the bolt is too large for a bur, an iron washer may be used. A washer may be made of tin, or two nuts may be used.
_66. Binding-Post._ Fig. 33. This is a suggestion for a combination of App. 44 and 47. It is useful in school apparatus. Wires may be permanently fastened on the right, under the nut, and a spring, as in App. 44, may be slipped on the metal strip at the left, which is held under the head of the bolt.
_67. Mercury Connector._ A cup of mercury may be used as a connector. Make a small hole about 1/4 in. in diameter and depth, in a piece of wood, and place 2 or 3 drops of mercury in this. The ends of wires dipped in this will be electrically connected.
_68. Connector._ Fig. 34. This shows how a wire may be fastened to one end of a short strip of tin. At the other end of the strip a slot is cut. This may straddle the body of a screw, or when left plain may be used to slip between the two metal strips shown in App. 43.