The Type-C hangar is a specific design of aircraft hangar built by the Royal Air Force during its expansion period of the 1930s. The hangar type generally measured in length, with a width of , and a clear height of . Whilst the type was designed, built and used during the expansion programme, installation of type-C hangars continued into the Second World War. By 1944, it was determined that in 64 RAF expansion period airfields, which were open at that time, at least one type-C hangar was present.
Design
Prior to the RAF Expansion Period of the 1930s, the largest hangar in RAF service was the Type-A, which measured in length, in width, in height, and had set of doors at one end only. During the expansion period, when permanent airfields were being constructed, it was deemed adequate for each squadron to have two Type-C hangars with annexes, in order to provide the necessary maintenance and storage space. The development of the 'C' Hangar was down to the design team of the Directorate General of Works, with a basic design registered as 2029/34 and labelled as Aeroplane Shed - Type "C". Larger bomber airframes dictated a hangar design that could accommodate aircraft with a wingspan of , and also having doors at either end of the hangar. Many hangars had offices or workshops attached to one side of the building; these were built to a width of and had differing designs.
Three sets of steel doors - high, were aligned at each end of the hangar, and were set into rails in the concrete floor. Each steel door consisted of two sheet sheets with a space between them; during wartime, this space was filled up to high with gravel as an anti-shrapnel feature should the hangar suffer from a bombing raid. The walls of the hangars were constructed either from brickwork (to a depth of ), or from reinforced concrete, thick.
The earlier sheds had gabled roofs, with an upright block at each end, and a few of these were built around the country (RAF Mildenhall was notable in having three of the type.) However, later examples had a sloping end roof (hipped), and some were built to a shorter length, the standard being described as having 12 bays. As most hangars were in length, each bay represented . Whilst the height of was excessive for those hangars on Fighter Command stations, the chance that the station could be re-roled to Bomber Command was easier to accomplish if needed without having to rebuild the hangars. However, once aircraft design had stabilised, a height of was found to be adequate, and so later hangars built towards the end of the expansion period were not as high as the earlier structures. The height of the hangars could be a mistake in the wrong environment; in September 1939, RAF Wick opened with four C1 hangars. As Wick was built on a treeless plain, the hangars were visible from miles away, which has led to some suggesting the hangars attracted the high number of air-raids that the base suffered. When it became apparent that the C1 hangars could not be built quickly enough post the outbreak of the Second World War, many airfields after this date were equipped with the Type-J hangar, which could be erected in a shorter timeframe.
By the end of 1944, 64 RAF airfields had at least one Type-C hangar. Most of these were airfields that had been built, or substantially improved during the expansion period of the 1930s. One example being RAF Waddington, which opened in 1916, and survived through the 1920s, having Type-C hangars built in the mid 1930s. Later examples, such as those at RAF Leeming in North Yorkshire (shown in the image below), were also known as the "Austerity" type, as these were built without the concrete or brick cladding of the 1930s build types (Leeming did not open until 1940). The original brickwork cladding the outside of the hangars would be in keeping with the brick built nature of the other structures on the base, and would also hopefully blend into the environment.