The cost of a book of twenty-four leaves three and a half inches square of English gold leaf of good ordinary quality is from 1s. 3d. to 1s. 6d., whereas the cost of a book of double thick pure gold leaf is 3s. to 3s. 6d. For tooled work it is worth paying the increased price for the sake of the advantages in colour and solidity; but for lines and edges, which use up an immense amount of gold, the thinner and cheaper gold may quite well be used.
Besides pure gold leaf, gold alloyed with various metals to change its colour can be had. None of the alloys keep their colour as well as pure gold, and some of them, such as those alloyed with copper for red gold, and with silver for pale gold, tarnish very quickly. These last are not to be recommended.
For silver tooling aluminium leaf may be used, as silver leaf tarnishes very quickly.
When the gold is pressed into the impressions of the tools with the pad of cotton-wool, they should be plainly visible through it.
The pattern must now be worked through the gold with the hot tools. The tools are taken from the stove, and if too hot cooled on a pad as for blinding-in. The heat required to leave the gold tooling solid and bright and the impressions clear will vary for different leathers, and even for different skins of the same leather. For trial a tool may be laid on the pad until it ceases to hiss, and one or two impressions worked with it. If the gold fails to stick, the heat may be slightly increased.
If the leather is slightly damp from the preparation the tools will usually work better, and less heat is required than if it has been prepared for some time and has got dry.
Before using, the faces of all tools must be rubbed bright on the flesh side of a piece of leather. It is impossible to tool brightly with dirty tools. A tool should be held in the right hand, with the thumb on the top of the handle, and steadied with the thumb or first finger of the left hand. The shoulder should be brought well over the tool, and the upper part of the body used as a press. If the weight of the body is used in finishing, the tools can be worked with far greater firmness and certainty, and with less fatigue, than if the whole work is done with the muscles of the arms.